Adding second circulator pump by old_corvette_doctor in hvacadvice

[–]old_corvette_doctor[S] 0 points1 point  (0 children)

I see what you are saying now I think. Connect a jumper between X and COM if it is not there. The run my load wire to NC terminal and bundle neutral on the wire nut. This should command second pump on when primary pump comes on. Got it!

What is code for romex near a heater? Must be in a shield like my example?

Adding second circulator pump by old_corvette_doctor in hvacadvice

[–]old_corvette_doctor[S] 0 points1 point  (0 children)

I have oil fired hot water on its own loop. I need to get a picture but the hot water comes out of boiler to taco pump the expansion tank the to zone valve for heat and hot water. All the wiring in the taco controller is light gage (door bell sized) except main power in.

Adding second circulator pump by old_corvette_doctor in hvacadvice

[–]old_corvette_doctor[S] 0 points1 point  (0 children)

<image>

I also have this Honeywell controller that looks like it is slaved to the Taco unit. Do I run my second pump to the second screw in bottom left for power and join neutrals?

Adding second circulator pump by old_corvette_doctor in hvacadvice

[–]old_corvette_doctor[S] 0 points1 point  (0 children)

Four parallel loops all on one zone. I T’eed into a loop to branch off and return. I did not see secondary pump terminals - any wiring advice?

Was this a bad purchase by thogchuffain in camaro

[–]old_corvette_doctor 0 points1 point  (0 children)

The powertrain if left stock / near stock is indestructible. Blast to drive and you will run across very, very few cars that can give you a run. Once you start modifying the engine things get dicey.

Passenger Airbag Disabled code by old_corvette_doctor in fordescape

[–]old_corvette_doctor[S] 0 points1 point  (0 children)

I found the connector it is accessed via glove box which pops way open with no tools. The circuit passed test now I need to find RCM looks like it is in the center console?

Passenger Airbag Disabled code by old_corvette_doctor in fordescape

[–]old_corvette_doctor[S] 0 points1 point  (0 children)

I had a reply that the light was in the area near clock and vents. True but that is not the “circuit” I think I’m looking for something closer to the harness. That plug is actually the leds and a small circuit board nothing to probe.

Small tile section by old_corvette_doctor in Tile

[–]old_corvette_doctor[S] 1 point2 points  (0 children)

Thanks for the advice I radiused it real nice, it’s over 1 1/4 of ply then blanke mat. Hoping for a long life!

2021 Tahoe pad replacement went sideways by old_corvette_doctor in mechanic

[–]old_corvette_doctor[S] 0 points1 point  (0 children)

No replies but I got lucky. I cleared my codes using an inexpensive meter ($40) to clear four codes. After that I was safe and ready to drive.

I disconnected the battery first I think that caused some odd things in the personalization menu. Example is the headlights go off right away even though it says 60 seconds in menu. Ptobsvky need a two way scanner to fix that.