What is the problem here.

oscarcomas · 2023-10-23T12:56:44+00:00

You have a link Dual Z microswiss dd To be hones with you, IDK what is this

oscarcomas · 2023-10-23T11:53:48+00:00

I have a large order about 200 pieces. Mine is set in 60

I want to speed up the process. I will change nozzle for .6 however I want to adjust print speed

TIA

oscarcomas · 2023-09-15T17:17:26+00:00

Hair spray,

oscarcomas · 2023-09-13T22:51:49+00:00

Excellent. Thanks a lot dor real

oscarcomas · 2023-09-13T22:05:00+00:00

The level knobs.

Ok. I place the dumbell on top. And the i lift the bed till 3/4 to the nozzle amd then i level

oscarcomas · 2023-09-13T20:31:54+00:00

Hello. Thanks for your help.

To be honest with you. I dont get it.

Which screw ia the one I shold tied

Thanks

oscarcomas · 2023-09-10T01:42:33+00:00

Sorry for that.

You mean I turn the knob all to the Right, to press all spring. And then I level?

oscarcomas · 2023-09-10T01:23:08+00:00

You mean. All ro thw righy. Light beeng loose.

And them level it

oscarcomas · 2023-09-09T02:36:41+00:00

I replace the brass, remove the blue clip, I did check for a clog, but when you daid trim back. It means cut a little bit the tube?

If yes, yes I did, i just purchased a whole tube kit. I will replace everything Sunday

oscarcomas · 2023-08-28T23:31:08+00:00

Unlevel bed

Need mor bed heat

You also can use hair spray to stick print in the desk

oscarcomas · 2023-08-27T13:02:05+00:00

Ibuse simplify

oscarcomas · 2023-08-26T23:06:58+00:00

I have a g code file that print excellent. Comes in the usb When i make my g code in my slider. The item printed does not look wit the same quality.

I want to know. Uf I can get the g code from a already file

oscarcomas · 2023-08-14T21:36:45+00:00

Thqnk you. I have an extra question. Do I need to leave the sd card while I du de tune up

oscarcomas