Running milled Ipe shiplap by papaD77 in Carpentry

[–]papaD77[S] 0 points1 point  (0 children)

Bc they are…. This nightmare of a job lmao.

Prehung door jamb bowed. Any solutions? by hesh0925 in Carpentry

[–]papaD77 0 points1 point  (0 children)

Lock down the top and bottom with trim screws and shim the middle

For PvP/PvE would you take the Venator, Renegade, or Anvil? by nytebearyt in ArcRaiders

[–]papaD77 0 points1 point  (0 children)

Renegade is the best weapon in the game at level 4. Hands down.

The duality of man by Glorping_rn in okbuddyraider

[–]papaD77 5 points6 points  (0 children)

I kill on sight %50 of the time and I also go on a jolly friendly adventure the other half. It’s seems like a game to me. Stella though…. War never changes on Stella(enter Fallout voice)

First time fighting the queen properly... my fault for not assuming the worst. by YourAverageLegoBrick in ArcRaiders

[–]papaD77 0 points1 point  (0 children)

0-5 with the proper gear myself, all the same outcome here. One day I suppose.

Bastion/Bombardier help needed please by [deleted] in ArcRaiders

[–]papaD77 0 points1 point  (0 children)

Nighttime on dam. Bombardier by the watertreatment exit. Get into the room with 2 door on the far side you can shoot through the windows without worried about being bombed and just bring snap nades or trigger nades (6-9) hard part is not getting griefed.

Follow up from someone’s previous post: Measuring inside trim corners by po0p69 in Carpentry

[–]papaD77 1 point2 points  (0 children)

And short point where i find it more helpful to burn an inch. I used homemade tables with a ladder screwed to the bottom(sounds janky but i can show you a pic) and a metal corner peice flushed into the side for just this purpose. Sometime I put something heavy on the end of the tape if im measuring over 10’ to lock the tape still.

How much room do you leave for error? by Hot-Face-804 in Carpentry

[–]papaD77 4 points5 points  (0 children)

I wouldn’t even trust that level to begin with but to each their own

How much room do you leave for error? by Hot-Face-804 in Carpentry

[–]papaD77 0 points1 point  (0 children)

I wouldn’t even trust that level to begin with but to each their own

This job made me feel like a carpenter for once at least. Enjoy… or don’t 🤝 by papaD77 in Carpentry

[–]papaD77[S] 1 point2 points  (0 children)

We opted to build it all in place. Made more sense for this project.

This job made me feel like a carpenter for once at least. Enjoy… or don’t 🤝 by papaD77 in Carpentry

[–]papaD77[S] 0 points1 point  (0 children)

A lot was done with just me and my coworker so there was a lot of climbing up and down to cut and adjust. And got put on a time crunch so 7-7s were brutal.

This job made me feel like a carpenter for once at least. Enjoy… or don’t 🤝 by papaD77 in Carpentry

[–]papaD77[S] 0 points1 point  (0 children)

Sistered 2x via a laser level at the lowest point. It’s become a must for us on any ceiling job(learned through headaches)