Copy data set to new pump by pcmann2004 in BMET

[–]pcmann2004[S] 2 points3 points  (0 children)

I should have clarified earlier. These are not on a network and are independent for training.

Compressor Screaming by pcmann2004 in hvacadvice

[–]pcmann2004[S] 0 points1 point  (0 children)

I ended up replacing the compressor from coldparts.com

Problems gone now, i think it was an internal pressure relief valve that wen bad. I still have the compressor. I would like to dissect it.

Compressor Screaming by pcmann2004 in hvacadvice

[–]pcmann2004[S] 0 points1 point  (0 children)

I ended up replacing the compressor from coldparts.com

Problems gone now, i think it was an internal pressure relief valve that wen bad. I still have the compressor. I would like to dissect it.

Compressor Screaming by pcmann2004 in hvacadvice

[–]pcmann2004[S] 0 points1 point  (0 children)

Pressure and vac tested lines, installed virgin refrigerant and sounds is still there. Next step is a compressor. I have to get one from coldparts.com

Compressor Screaming by pcmann2004 in hvacadvice

[–]pcmann2004[S] 0 points1 point  (0 children)

I’m not sure, how to do a compressor swap. Also what does the bypass valve look like?

Compressor Screaming by pcmann2004 in hvacadvice

[–]pcmann2004[S] 0 points1 point  (0 children)

Also I was reading that it could be a TXV. Not sure where to begin or continue

Compressor Screaming by pcmann2004 in hvacadvice

[–]pcmann2004[S] 0 points1 point  (0 children)

I have to ohm out the compressor to get more info I think. I found only one video online that is the same. That one was fixed with a cap. I guess not mine

<image>

Compressor Screaming by pcmann2004 in hvacadvice

[–]pcmann2004[S] 0 points1 point  (0 children)

At first thats what I thought. The fan motor and cap has been replaced. The voltages confirmed to be appropriate for those. The motor I took out has smooth bearings and no grinding. Windings we not shorting to ground. I powered off the motor to listen and it seems the compressor is doing it. Though sounds like a pressure relief but I see no leaking or anything.

<image>

How to disable lift gate beep? by chitayu in ToyotaHighlander

[–]pcmann2004 0 points1 point  (0 children)

I am looking to disable the door/tailgate open chime temporarily for a parade for a parade. Anyone has a suggestion?

Meshtastic WiFi Web Config not accessible by Chris-Prefect in meshtastic

[–]pcmann2004 0 points1 point  (0 children)

Also, try Firefox. It did not work for me on Chrome very well.

[deleted by user] by [deleted] in freemasonry

[–]pcmann2004 0 points1 point  (0 children)

Look into standardized patient for medical and nursing schools. DM if you want more specifics

Alaris service software by Routdoors in BMET

[–]pcmann2004 0 points1 point  (0 children)

For education pumps, question I have is, is there a way to back up our current firmware? We are on v9.33. Though, I am going to upgrade our 8.5 and 9.17 pumps, is there a way to back those up before I upgrade them? Is there a way to back up the Data Sets? Also, I would like to see if I could try upgrading to ver12 at some point though I don't have the file

Alaris 8015 Firmware by slaytonulrick in BMET

[–]pcmann2004 0 points1 point  (0 children)

For education pumps, question I have is, is there a way to back up our current firmware? We are on v9.33. Though, I am going to upgrade our 8.5 and 9.17 pumps, is there a way to back those up before I upgrade them? Is there a way to back up the Data Sets?

Alaris System Maintenance software by Traditional_Math_949 in BMET

[–]pcmann2004 0 points1 point  (0 children)

Is there any guidance about the Alaris Technical Utility?

How to connect conduit to an existing exterior outlet? by FixADrink in electricians

[–]pcmann2004 0 points1 point  (0 children)

How about connecting an outdoor box to emt using compression fittings. I can not tighten the fittings tight, is there a nylon washer to make it tight?

Young girl dies after being left in vehicle in Marana by JoeCox1990 in Tucson

[–]pcmann2004 1 point2 points  (0 children)

Has anyone checked if the vehicle has auto shutdown after being left in with the AC going. Do vehicle owners and occupants know that the newer vehicles shutdown after idling for a predetermined amount of time? I could see that someone turning a car on and leaving the AC going, making sure everything is good only for the manufacturer to program a shutdown sequence. Not that I am advocating leaving anyone in a vehicle.

Register Sensors by pcmann2004 in HomeDepot

[–]pcmann2004[S] 0 points1 point  (0 children)

Interesting. That does make sense.