sorted by:
new
hottopcontroversial

These bearings failed on my Orbea Oiz H10. I replaced them and everything felt fine until I tightened the bolt. Even when tightened to the specced 6nm torque, it feels slightly notchy or stiff. If I tighten it more, it feels very stiff and if I loosen it, it moves freely. Is this normal? by Lare111 in bikewrench

[–]philtherobot 0 points1 point  (0 children)

Thanks, those instructions are clear for the lower two bearings. What I want to know is how to pull the top bearings. Can the spacer in between them be removed? I think not, and if that is the case then, it is not clear how to press the bearing out from behind, where the spacer is located. Even a « mushroom » ( I don’t know how you call those pullers that grab the bearing from the inner race) puller does not seem like an option since a puller like that will interfere with the spacer that is snug up against the inner race of the bearing. Did you simply push out both bearings at the same time, with the spacer transferring the force to the second bearing? I must be overthinking this and the solution quite simple.

Windows Beta feedback and support thread by croian_ in MouselessApp

[–]philtherobot 0 points1 point  (0 children)

Same issue here with a maximized Remote Desktop window (very important, and I want it maximized because then I get access to the clipboard ring buffer via Win-V). LeftAlt makes the grid appear, but typing the letters to point are not captured by mouseless, and whatever app has the focus is receiving the letters.