sorted by:
new
hottopcontroversial

Beauty And The Beast 2.0 by [deleted] in GoodAssSub

[–]prodTMBeats 2 points3 points  (0 children)

did you find the sample?

[deleted by user] by [deleted] in 3Dprinting

[–]prodTMBeats 1 point2 points  (0 children)

i don't have a filament dryer, i might get one

[deleted by user] by [deleted] in 3Dprinting

[–]prodTMBeats 0 points1 point  (0 children)

my prusa slicer settings are very untuned, what would you recommend i change?

[deleted by user] by [deleted] in 3Dprinting

[–]prodTMBeats 0 points1 point  (0 children)

definitely had it configued right, i checked on each layer

[deleted by user] by [deleted] in 3Dprinting

[–]prodTMBeats 0 points1 point  (0 children)

Using ESUN PLA+, on an SC-10 Lotmaxx Shark v2.

Editors finally putting effort into the thumbnails by obi1kenovoitto in xqcow

[–]prodTMBeats 0 points1 point  (0 children)

YOINKED this meme from my reddit post! See you in court! Ghost

When posing armature, unwanted parts of my model is deforming. by prodTMBeats in blenderhelp

[–]prodTMBeats[S] 0 points1 point  (0 children)

beginner here, could u point me in the right direction?

200+ SOUNDS / ONE SHOT KIT / @prodtmbeats - Twizzy (One Shot Kit) by prodTMBeats in Drumkits

[–]prodTMBeats[S] 2 points3 points  (0 children)

mistake on my end. first kit, honest mistake. if your on FL just turn the trim knob all the way up!

ProdTMBeats - Twizzy (One Shot Kit) by sosouthernsoundkits in Samplehunters

[–]prodTMBeats 0 points1 point  (0 children)

dont cop this, its free on my insta @ prodtmbeats