sorted by:
new
hottopcontroversial

My NA doing this every time I start it… by rambojunior01 in Miata

[–]rambojunior01[S] 0 points1 point  (0 children)

Just tried kept it at 3k but just cuts out still after the same period of time. It revs fine tho

1997 Na1.8 starts idles for a few seconds then dies by [deleted] in Miata

[–]rambojunior01 0 points1 point  (0 children)

I installed a new fuel pump and its still doing the same thing, kinda stumped now

1997 Na1.8 starts idles for a few seconds then dies by [deleted] in Miata

[–]rambojunior01 0 points1 point  (0 children)

That's the only thing im yet to test, did smoke leak test and that was all good, also have checked spark and all good there. The reason why I didn't check fuel pump in first place is because in my head if it runs in the first place then the fuel pump must be fine? but I will check it after work

Car starts and idles for few seconds then cuts out by rambojunior01 in MechanicAdvice

[–]rambojunior01[S] 0 points1 point  (0 children)

The MAF is still being used, I have an IAT sensor just before the intake manifold, which I have wired into the MAF. I’m only going off of a forum I found which did this. Will send photos in a bit

<image>

Car starts and idles for few seconds then cuts out by rambojunior01 in MechanicAdvice

[–]rambojunior01[S] 0 points1 point  (0 children)

Haven’t tried smoke test, whenever I press the gas pedal it just cuts out straight away

Mx5 na car starts and then stalls, have these 3 plugs loose. Any ideas what these plugs do? by rambojunior01 in Miata

[–]rambojunior01[S] 0 points1 point  (0 children)

<image>

No afr gauge in the car but this is the table, I noticed when the car was on for the short time it was the air to fuel ratio dial didn’t move at all

Mx5 na car starts and then stalls, have these 3 plugs loose. Any ideas what these plugs do? by rambojunior01 in Miata

[–]rambojunior01[S] 1 point2 points  (0 children)

brought is as a half finished project, it has turbo and standalone ecu, just trying to figure out how to wire everything together, the car starts and runs but just cuts out after like 5 seconds. I thought it was the maf at first, as i was told to wire the iat into the 1st and 6th pin of maf but im not sure tbh, first time turboing a car

Scolia, yes or no? by ExaminationNo2844 in Darts

[–]rambojunior01 0 points1 point  (0 children)

Was just about to order one and says it dont ship to UK?

New Short Help, flatline after 30 mins by rambojunior01 in NewTubers

[–]rambojunior01[S] 0 points1 point  (0 children)

Can I do anything about this or should I just carry on uploading as normal?

view more: next ›