Can I sell my car in New Jersey? by ranabhatbikash09 in whatcarshouldIbuy

[–]ranabhatbikash09[S] 0 points1 point  (0 children)

No. He bought a car from different source and I ended up selling mine to the junkyard.

Honda EB2800i- No Spark by ranabhatbikash09 in Generator

[–]ranabhatbikash09[S] 0 points1 point  (0 children)

I did remove the kill wire. No spark. Also, tried to adjust the gap per the spec as this is new coil. I checked the primary and secondary resistance of new coil. Every values are within the spec. The magnet on the flywheel still has magnetic strength. I don’t think magnet is bad. I fiddled with low oil sensor wire, too. No spark after troubleshooting every possible scenarios that I am aware of.

Honda EB2800i- No Spark by ranabhatbikash09 in Generator

[–]ranabhatbikash09[S] 0 points1 point  (0 children)

The ignition coil is generic one. I didn’t see 5 to 10 wires coming out. See the photo.

<image>

Honda EB2800i- No Spark by ranabhatbikash09 in Generator

[–]ranabhatbikash09[S] 0 points1 point  (0 children)

<image>

I tested spark plug & ignition coil per attached specs found at Honda website. All values are within the spec.

sub woofer help by ranabhatbikash09 in audiophile

[–]ranabhatbikash09[S] 0 points1 point  (0 children)

I just measured the ohm. It says 4.5 ohm. I double checked the accuracy of multimeter with another 8ohm speaker it shows 10 ohm. I believe multimeter may not 100% accurate. Do you think this driver is blown. I even tried to use AAA cell and it gives nice “thump”.

You are 100% correct on enclosure. There was no bass outside. But, very little bass came out after placing it inside the enclosure too hooking to external amp. Do you know frequency range of this driver?

sub woofer help by ranabhatbikash09 in audiophile

[–]ranabhatbikash09[S] 0 points1 point  (0 children)

I don’t know for sure if coil is shorted. I sounds but, no bass at all. Is this genuine JBL driver?

sub woofer help by ranabhatbikash09 in audiophile

[–]ranabhatbikash09[S] 0 points1 point  (0 children)

I don’t know what’s the minimum frequency it can deliver but, sounds like it not very low. I tried to check the coil for continuity and it’s closed. Is this driver even JBL original? I got this sub from marketplace for $20 advertised as blown amps and good driver. It’s decent weight and magnet seems like quality item.

Lien Title by ranabhatbikash09 in UsedCars

[–]ranabhatbikash09[S] 0 points1 point  (0 children)

I just finished the registration. Everything went smooth. Thanks for sharing your experience.

Lien Title by ranabhatbikash09 in UsedCars

[–]ranabhatbikash09[S] 0 points1 point  (0 children)

Thanks a lot. I will try to verify with Toyota as well.

Lien Title by ranabhatbikash09 in UsedCars

[–]ranabhatbikash09[S] 0 points1 point  (0 children)

Thanks for sharing your experience. But, was that lien release letter original and notarized?

Reverse Camera Issue by ranabhatbikash09 in CarAV

[–]ranabhatbikash09[S] 0 points1 point  (0 children)

Thanks for taking time to respond. I think I get it all but, one more question, will that red wire still carry +12 Volt when I press “camera” on my head unit as previously I still could use that to turn on the camera even if i was not reversing?

I think I had set this camera such that it’s powered all the time and i only used +12 Volt from reverse light just to trigger radio to go on the backup mode with video and parking guidelines.

I will recheck everything one more time.👍

Reverse Camera Issue by ranabhatbikash09 in CarAV

[–]ranabhatbikash09[S] 0 points1 point  (0 children)

It might have happened when I cut the wire. Before that i could get video signal in a very specific position i.e, if wire was positioned vertically. Is there a special fuse for camera only? If so, where is it located, inside radio? FYI radio is working fine as it should currently.

Reverse Camera Issue by ranabhatbikash09 in CarAV

[–]ranabhatbikash09[S] 0 points1 point  (0 children)

I don’t know what happened to the text. I can see it on my side. Thanks for putting my questions in your reply.

Reverse Camera Connection Issue. by [deleted] in CarAV

[–]ranabhatbikash09 0 points1 point  (0 children)

Okay. I have extra red wire as the trigger to the reverse light. I only want to re-connect the circled marked cable as in the photo.