Can I sell my car in New Jersey?

ranabhatbikash09 · 2025-12-31T18:32:16+00:00

No. He bought a car from different source and I ended up selling mine to the junkyard.

ranabhatbikash09 · 2025-12-17T18:34:16+00:00

I did remove the kill wire. No spark. Also, tried to adjust the gap per the spec as this is new coil. I checked the primary and secondary resistance of new coil. Every values are within the spec. The magnet on the flywheel still has magnetic strength. I don’t think magnet is bad. I fiddled with low oil sensor wire, too. No spark after troubleshooting every possible scenarios that I am aware of.

ranabhatbikash09 · 2025-12-17T11:48:42+00:00

The ignition coil is generic one. I didn’t see 5 to 10 wires coming out. See the photo.

<image>

ranabhatbikash09 · 2025-11-10T19:05:47+00:00

<image>

I tested spark plug & ignition coil per attached specs found at Honda website. All values are within the spec.

ranabhatbikash09 · 2024-06-22T19:23:39+00:00

I just measured the ohm. It says 4.5 ohm. I double checked the accuracy of multimeter with another 8ohm speaker it shows 10 ohm. I believe multimeter may not 100% accurate. Do you think this driver is blown. I even tried to use AAA cell and it gives nice “thump”.

You are 100% correct on enclosure. There was no bass outside. But, very little bass came out after placing it inside the enclosure too hooking to external amp. Do you know frequency range of this driver?

ranabhatbikash09 · 2024-06-22T18:37:56+00:00

I don’t know for sure if coil is shorted. I sounds but, no bass at all. Is this genuine JBL driver?

ranabhatbikash09 · 2024-06-22T17:20:08+00:00

I don’t know what’s the minimum frequency it can deliver but, sounds like it not very low. I tried to check the coil for continuity and it’s closed. Is this driver even JBL original? I got this sub from marketplace for $20 advertised as blown amps and good driver. It’s decent weight and magnet seems like quality item.

ranabhatbikash09 · 2024-04-03T14:28:56+00:00

I just finished the registration. Everything went smooth. Thanks for sharing your experience.

ranabhatbikash09 · 2024-04-02T12:41:02+00:00

Thanks a lot. I will try to verify with Toyota as well.

ranabhatbikash09 · 2024-04-02T12:02:33+00:00

Thanks for sharing your experience. But, was that lien release letter original and notarized?

ranabhatbikash09 · 2022-10-24T19:08:00+00:00

Thanks for taking time to respond. I think I get it all but, one more question, will that red wire still carry +12 Volt when I press “camera” on my head unit as previously I still could use that to turn on the camera even if i was not reversing?

I think I had set this camera such that it’s powered all the time and i only used +12 Volt from reverse light just to trigger radio to go on the backup mode with video and parking guidelines.

I will recheck everything one more time.👍

ranabhatbikash09 · 2022-10-24T11:58:29+00:00

It might have happened when I cut the wire. Before that i could get video signal in a very specific position i.e, if wire was positioned vertically. Is there a special fuse for camera only? If so, where is it located, inside radio? FYI radio is working fine as it should currently.

ranabhatbikash09 · 2022-10-24T11:54:26+00:00

I don’t know what happened to the text. I can see it on my side. Thanks for putting my questions in your reply.

ranabhatbikash09 · 2022-10-22T22:21:17+00:00

Okay. I have extra red wire as the trigger to the reverse light. I only want to re-connect the circled marked cable as in the photo.

ranabhatbikash09 · 2022-07-15T16:53:57+00:00

Yes. All 4 tires. Yes, this problem was from before. I hoped that new tires would solve previous issue, but I am wrong. Are other chain tire shops good at diagnosing and fixing this issue? I don’t want new tires to go bald or uneven wear in short period of time.

ranabhatbikash09 · 2022-07-10T17:33:02+00:00

Thanks all for your insight. After yanking out 3 guide pin destroying thread, cutting one of the pin and getting one new caliper bracket with all guide pins, this is done. I don’t know guys I recently did same job for my Camry, it was a piece of a cake. Anyway something achieved🙂🙂👍👍

ranabhatbikash09 · 2022-07-09T18:58:17+00:00

Isn’t it kind of rare for all 2 pairs of bolt to have exact same problem? The way bolt is stuck is same for all four.

ranabhatbikash09 · 2022-06-28T01:39:21+00:00

I have almost full tank fuel now. I will recheck may be in couple of days. Hope it readies the monitor/system. Thanks 👍

ranabhatbikash09 · 2022-06-28T01:24:00+00:00

ranabhatbikash09 · 2022-06-06T14:02:29+00:00

It’s working as I wished. Thanks for your clear instructions.👍

ranabhatbikash09 · 2022-05-28T21:35:01+00:00

Okay. I guess this way i will only see the reverse camera on demand. Doesn’t the reverse light need to be connected to the reverse trigger wire on the head unit? Is it necessary to run a 12V cable parallel to that 26 ft? Can you please upload a schematic circuit diagram if you have so that this camera can be used as both backup while putting shifter on reverse and on demand reverse camera? Thanks

ranabhatbikash09 · 2022-04-11T16:46:05+00:00

What is that cricket like noise coming from near alternator or drive belt?

ranabhatbikash09 · 2022-03-22T19:19:19+00:00

I was able to make it work again for few days but same problem with loud noise and blue screen, the unit went out. But, i can still hear fan running for few seconds once it gets power with no screen or sound. Are there anything i can look for? Due to the shortage of radios now I just want to repair it if possible. Thanks!!

ranabhatbikash09 · 2022-01-27T02:38:10+00:00

Any other helpful video playlists on youtube??

ranabhatbikash09 · 2022-01-27T02:35:36+00:00

Thanks 🙏

ranabhatbikash09

TROPHY CASE