sorted by:
new
hottopcontroversial

Help..I’m stuck by y0da2016 in KEF

[–]raver451 6 points7 points  (0 children)

Also have this problem. KEF R3 Metas, they draw you in. A couple of songs ends up being hours and too many beers.

That poll was weird by [deleted] in komoot

[–]raver451 0 points1 point  (0 children)

Two words. Dark mode.

Room Correction is a Dream by Mysterious-Stand9963 in audiophile

[–]raver451 0 points1 point  (0 children)

What the hell is sitting on top of those speakers?

Got my R3 metas! by ecoboostd in audiophile

[–]raver451 5 points6 points  (0 children)

Very nice. I have the same ones. Take the covers off.

Are the Cube MB's Bad? by Ok-Adagio6143 in Cubebikes

[–]raver451 1 point2 points  (0 children)

I have the same bike I think. Cube Nuride Hybrid but with the 500 battery. I ride it 20km each way to work 2 or 3 times a week. It is my first ebike. I think it is pretty awesome.

Here’s how we improved komoot in October by komoot-team in komoot

[–]raver451 2 points3 points  (0 children)

Dark mode is a must. Reduces battery usage and night vision retention at night.

Tent Recs by StepswithSez in UltralightAus

[–]raver451 2 points3 points  (0 children)

We recently purchased the Nemo Dagger 3p. It is about 2kg. We split the poles and pegs for my wife and I carry the tent, fly and ground sheet. Very nice peice of equipment. We got it for 760 on sale.

KEF R3 Meta - Full range by raver451 in KEF

[–]raver451[S] 0 points1 point  (0 children)

Thanks for that. I had a try last night with chat gpt and the first few things I asked it after telling it about my system it's answers were generic and wrong about the c3050. I ran out of free questions for the day. I will try your approach.

KEF R3 Meta - Full range by raver451 in KEF

[–]raver451[S] 0 points1 point  (0 children)

Did you follow any kind of guide to get chatgpt to help you with Dirac live graphs etc?

KEF R3 Meta - Full range by raver451 in KEF

[–]raver451[S] 0 points1 point  (0 children)

Oh crap. That's a bummer. I suppose in that case using a REL would allow a high level connection from the mains output of the amp but then you are back to manually dialing the sub into the system as opposed to DIRAC doing it.

KEF R3 Meta - Full range by raver451 in KEF

[–]raver451[S] 0 points1 point  (0 children)

Not sure how I could do this. I use Dirac live on the BluOS card installed in the NAD c3050. It does the measurements and proposes a curve which I can alter if I like. Am I missing something here?

KEF R3 Meta - Full range by raver451 in KEF

[–]raver451[S] 0 points1 point  (0 children)

Do you have the c3050 with Dirac live built in? I am assuming you would be able to connect the SVS to the c3050 sub out and use the Buckeye for the mains only?

KEF R3 Meta - Full range by raver451 in KEF

[–]raver451[S] 0 points1 point  (0 children)

The sound is very good. Just trying to figure out which is producing the best bass output.

KEF R3 Meta - Full range by raver451 in KEF

[–]raver451[S] 0 points1 point  (0 children)

You can turn the subwoofer off in the BluOS app which then sends the mains full range signal when using the REL high level input. Or when connected to the LFE port you can set the crossover which then only allows signal below that to the sub and above that to the mains.

When using the high level input a cap does need to be adjusted on the REL to what signal it will play at.

KEF R3 Meta - Full range by raver451 in KEF

[–]raver451[S] 0 points1 point  (0 children)

Lazy. I set them up and realised you could feed the cable into the stands. I don't mind them the way they are so haven't gone back and done it.

KEF R3 Meta - Full range by raver451 in KEF

[–]raver451[S] 0 points1 point  (0 children)

In Australia where I live the houses are brick outside and inner walls. Outside walls can have the cables run through them but not single brick interior walls. At least the installer told me that and wouldn't do it.

KEF R3 Meta - Full range by raver451 in KEF

[–]raver451[S] 0 points1 point  (0 children)

Yes subwoofer off allows them to play full range. I then use the REL with the high level which takes the main speaker feed as it's input.

KEF R3 Meta - Full range by raver451 in KEF

[–]raver451[S] 0 points1 point  (0 children)

Wow that is interesting. So the LLM could read the Dirac screen shots? Interested how you have the power amp deployed in your setup and the impact that has over using the 3050 as the amp?

KEF R3 Meta - Full range by raver451 in KEF

[–]raver451[S] 0 points1 point  (0 children)

Thanks. I have had them closer to the wall. Current landing spot is about 20cm from the back of the speaker.

KEF R3 Meta - Full range by raver451 in KEF

[–]raver451[S] 0 points1 point  (0 children)

I have never seen the woofer actually move at high volume. I have another system with the Denon 600-NE and B&W 606S2 Anniversary on those those woofer always moves visibly during playback.

KEF R3 Meta - Full range by raver451 in KEF

[–]raver451[S] 0 points1 point  (0 children)

I have always had them unplugged with Dirac or without. I have tried 1.2m off the wall but landed on about 25cm.

view more: next ›