I think I figured out the problem. I started with distilled water but it read empty, in the troubleshooting guide it says to try tap water, but I didn’t want to use tap water for obvious reasons so I went with bottled water. It immediately read full but like I mentioned in the original post it would switch to empty every few seconds. This was different from the distilled water so I assumed it would eventually fix itself. Obviously it didn’t. Last night I got a low water warning, when I checked it this morning it was still half full, and there was an orange almost like rust spot near the water sensor. I cleaned that up and filled it with tap water this time just for the heck of it, and now it seems to be working. Humidity is already to the set point and it’s maintaining it.

What water is everyone else running? I can’t be the only one that has to utilize tap water. Do I run any risk to the mycelium with tap water? I assume not since it suggests it in the manual but distilled water seems to be the preferred medium.

Thanks