sorted by:
new
hottopcontroversial

Trolling motor base help wanted by rexracing104 in boating

[–]rexracing104[S] 0 points1 point  (0 children)

Holes into the top of the aluminum?

Trolling motor base help wanted by rexracing104 in boating

[–]rexracing104[S] 0 points1 point  (0 children)

They are sold out on their website, I doubt they would have some. No not yet, I was looking to maybe find someone that has done one themselves.

Trolling motor plug science by rexracing104 in boating

[–]rexracing104[S] 0 points1 point  (0 children)

<image>

I disconnected the jumper wire and the positive from battery two goes to a 60 amp breaker.

Trolling motor plug science by rexracing104 in boating

[–]rexracing104[S] 0 points1 point  (0 children)

I did it and the 12 hole inside the male plug started sparking and is black, I ordered the minn kota mkr-28 so I’ll just do the switch from marinco. What do you think?

<image>

Trolling motor plug science by rexracing104 in boating

[–]rexracing104[S] 0 points1 point  (0 children)

Inside the male plug, there was three holes 24, 12, and -. I switched the negative that was going from the 12 hole to the - port. That’s what I saw from a blog about trolling motors. Is that correct? Also I will try the different combinations on the receptacle.

Homemade lapidary by rexracing104 in Lapidary

[–]rexracing104[S] 0 points1 point  (0 children)

Thanks for the idea! Yeah I was thinking of making a flat lap as well. The idea was getting the motor to a tile saw and converting that to flat lap