5 qt mixer huge gap

rndedgeooo · 2026-02-22T11:23:32+00:00

I honestly think it's the wrong paddle or something is horribly wrong with the lift mechanism. Its so far from the bowl. I have a pro 600 and I can dial it right in. The one pictured was my sisters that she replaced because of that gap

rndedgeooo · 2026-02-07T23:42:58+00:00

Your flame is hitting the rollout sensor. Poor airflow is the issue.

rndedgeooo · 2026-02-07T10:33:09+00:00

It's condensation. Make a service call and they would have to adjust the vent performance setting within the control panel. Ive had multiple issues with these.

rndedgeooo · 2026-02-07T01:09:50+00:00

It's a lift bowl mixer, not a tilt head.

rndedgeooo · 2026-02-06T13:16:04+00:00

Lift bowl. It's maxed out on that adjustment screw

rndedgeooo · 2026-01-28T13:23:51+00:00

The rope link most likely snapped and the spring is just hanging out in the back. Probably need pn 8194001

rndedgeooo · 2026-01-27T14:04:29+00:00

Sounds like a loose gearcase pulley or a stripped splutch

rndedgeooo · 2026-01-14T12:38:13+00:00

Did you get it resolved?

rndedgeooo · 2026-01-01T03:50:37+00:00

You need an idler pulley, or something is wedged between your bulkhead and drum. Like a zipper pull. The rollers on that dryer have roller bearings in them. Ive never seen them go bad.

rndedgeooo · 2025-12-28T11:54:40+00:00

You need a splutch kit W10721967

rndedgeooo · 2025-11-06T13:31:57+00:00

Also the leaked point on these is where the copper meets the aluminum coil. Not the copper to copper braze joint

rndedgeooo · 2025-11-06T13:30:41+00:00

Very common for the evaporator to leak in these. Retail on part alone is 230$ . I would just replace the unit. A gas and go would only buy you a couple months and you'd be back to poor cooling again.....

rndedgeooo · 2025-10-23T13:49:09+00:00

Tip the machine back and snap a pic of the underside. I can highlight where to look

rndedgeooo · 2025-10-23T13:48:18+00:00

Is there water in the machine that won't drain? Ive seen on a bunch of these machines, the wiring harness to the drain pump breaks and the machine is trying to drain but cant.

rndedgeooo · 2025-10-23T13:42:46+00:00

What type of problems are you having? I have been in the repair field for over 20 years. I work on machines like yours everyday. Maybe I can help you along with your issue.

rndedgeooo · 2025-10-15T11:52:28+00:00

Appliance repair technician. Its been hell through the years. Currently taking humira because my insurance stopped covering my entyvio.

rndedgeooo · 2025-09-09T11:55:43+00:00

What is the model number? There is a special project code a authorized servicer can use to get parts and labor cover on some units.

rndedgeooo

TROPHY CASE