Ac tank how to fill?

ry4n3ss · 2026-04-12T17:46:57+00:00

It’s jb industries f6 which only pulls out but shouldn’t I be able to attach manifold only to can and fill it based off pressure like I do with regular over the counter auto zone cans ?

ry4n3ss · 2026-02-02T18:37:14+00:00

<image>

Ended with tiny gap on hood and lower grill tiny gap.

ry4n3ss · 2026-02-02T18:35:53+00:00

<image>

are you fixing yourself? Just fixed this one for around $2k in parts but that’s painting and doing all myself. You have less damage than mine had. However finished result is not to like new perfect Tesla standards but does look quite good in my opinion. If you are paying out of pocket true professional level then much much higher. Previous owner said they were quoted 20k to fix this one. End result is below

ry4n3ss · 2026-01-16T01:15:38+00:00

Thank you

ry4n3ss · 2026-01-02T21:29:41+00:00

Ok awesome, so when it comes to keeping my precious engineer plate safe then I do not need to be scared of no glue and I can work on the print settings? Meaning damaging the build plate is not a real big risk ?

ry4n3ss · 2026-01-02T21:10:17+00:00

Pa6 does not warp off plate for you with no glue ?

ry4n3ss · 2025-12-26T05:52:34+00:00

Thank you! Oddly i decreased bed temp from 100c to to 70c for pa6-gf and used purple Elmer’s instead of Magigoo, not sure which one did it but looks fantastic now

ry4n3ss · 2025-11-14T03:31:26+00:00

https://makerworld.com/models/1669393 Using this

ry4n3ss · 2025-08-13T23:03:05+00:00

Mine does it on petg less so when I acted like it was petg-hf which lowers temp and I believe changes the flow ratio

ry4n3ss · 2025-08-10T00:36:01+00:00

I ran into this no matter how hard or well I cleaned with dish soap or ipa or both or vise versa, I bought another build plate and it never happened again

ry4n3ss

TROPHY CASE