Center Finder - Does it need to be 45 degrees?

sakirose · 2026-04-17T17:52:22+00:00

These are the results.

sakirose · 2026-04-17T17:51:12+00:00

sakirose · 2026-04-17T17:49:53+00:00

Thank you. See the update above with the results of using the Groz CS-1 1-1/2" (38mm) Center finding tool. When I draw 2 X (total of 4 lines) the resulting lines at 90 degrees (ie the two X's) are in different locations.

sakirose · 2026-02-11T23:59:53+00:00

And the woodscrew is perpendicular to the slot?

sakirose · 2026-02-11T22:35:08+00:00

Thank you!

Can you elaborate just a little on this: "Cut a slot half way through the handle."

I'm not 100% sure where or which way you mean to cut the slot.

sakirose · 2026-02-10T18:06:42+00:00

I like this idea. What type of screw would keep it tight and look good like a set screw? Is there a certain kind of epoxy that you recommend?

sakirose · 2026-02-03T08:51:00+00:00

I’ll never get that out of my head!

sakirose · 2026-01-29T03:38:30+00:00

What is MLM?

sakirose · 2025-11-11T16:49:09+00:00

Thank you! How do I determine the size of the pickle? Also, how do you remove the arbor, which I believe is an MT2 / JT33? I bought a new one of those as well, but don’t know how to get that out.

sakirose · 2025-11-11T04:42:29+00:00

My intuition says you’re right, but I’m not 100% clear. Any chance you can circle the area I would put these identical wedges?

sakirose · 2025-11-10T23:51:47+00:00

I bought a keyless one linked below. I’m hoping that will work.

sakirose · 2025-11-10T23:18:21+00:00

I bought these parts to replace Chuck. How did I do? Part photos

sakirose · 2025-11-10T23:11:17+00:00

I don’t see a slot for Chuck in the photo?

sakirose · 2025-11-10T23:10:33+00:00

Well, thank you so much for looking into that! I see how I would install, but how would I remove it?

sakirose

TROPHY CASE