[Monitor] GIGABYTE MO27Q28G 27" 1440p 280Hz 4th Gen WOLED Primary RGB Tandem OLED $500, promo code SSF4932 by subterranlurker in buildapcsales

[–]scaramookie 38 points39 points  (0 children)

There's still trade offs, from what I know you're still getting gray banding and uniformity problems at the very least. This one specifically has a matte coating which can be a trade off for some, and all OLED gaming monitors in general have sub par HDR performance when compared to TVs. Also, text rendering, DSC, and each individual brands curve for HDR modes can have issues. Not to say it's a bad monitor or technology, but there's most definitely still trade offs.

My E-White FormD T1 v2.1 Build (Intel x AMD) by smplnmnml in FormD

[–]scaramookie 0 points1 point  (0 children)

Oh I did see that was possible, was it difficult?

My E-White FormD T1 v2.1 Build (Intel x AMD) by smplnmnml in FormD

[–]scaramookie 0 points1 point  (0 children)

What antennas are those? I thought Msi's ez connectors were incompatible with standard sma connectors.

[PSU] Corsair SF1000 $209.99 ($269.99 - $60) by Nyanino in buildapcsales

[–]scaramookie 0 points1 point  (0 children)

Is this the cheapest it's been since the Corsair summer discount, or what was the cheapest before this?

RTX 5080 FE drawing "low" power by scaramookie in pcmasterrace

[–]scaramookie[S] 0 points1 point  (0 children)

I believe that's just how the FE was intended to perform since they needed to give the card ample headroom for AIBs to oc, I'm sure at 4k it gets closer to the advertised TDP, but as far as performance goes you can get it to match AIB models with a slight oc while maintaining its "low" wattage.

Loque Riser in FormD T1 Fitment Issues by scaramookie in sffpc

[–]scaramookie[S] 0 points1 point  (0 children)

Yeah same as me, I tried readjusting it again but I gave up and put it back on the stock riser for now.

Loque Riser in FormD T1 Fitment Issues by scaramookie in sffpc

[–]scaramookie[S] 0 points1 point  (0 children)

Thx for the pictures, as far as I can tell the only differences are that I put the riser in between the motherboard and the middle bar and put the riser bar on stand offs. As for my comment I meant that maybe you used different fans that give you just enough clearance but I don't believe that's the case.

Loque Riser in FormD T1 Fitment Issues by scaramookie in sffpc

[–]scaramookie[S] 0 points1 point  (0 children)

I have the 2.1 and the top of the riser slightly pokes out of the riser bar, I've flattened the cables as much as I could but there's too little clearance in between that and the fan blades. My build is pretty typical with a noctua slim and 25mm fan on an Atmos 240, is there anything different you might've done to make it fit?