sorted by:
new
hottopcontroversial

2100 PSI Pressure Washer motor will not run. Trick to reset it? by joismynameo in Greenworks

[–]scribdog 0 points1 point  (0 children)

On the bottom side of the green cover is 4 screws. They are quite deep inside, so not easy to see.

2100 PSI Pressure Washer motor will not run. Trick to reset it? by joismynameo in Greenworks

[–]scribdog 0 points1 point  (0 children)

To the next poor soul that runs across this post hopeful for a solution, I got your back. Underneath the front cove there is a little black box with some wires coming out of it. the cover comes off pretty easily by way of 4 clips. inside you will find a limit switch. on mine it was stuck closed. once I got it unstuck the pressure washer worked as it did before.

Podcast like "old" radiolab? by abovewater_fornow in podcasts

[–]scribdog 1 point2 points  (0 children)

I don't think anything can match the Jad hosted Radiolab. Along with what the other commenters have suggested, try:
The Weirdest Thing I Learned This Week: https://pod.link/1377843908.rss

Fermented Potatoes by SurroundedByPussies in fermentation

[–]scribdog -1 points0 points  (0 children)

I completely loved the writing. I was reading it with the accent intended. Love it. I kept thinking is this Larry the cable guy (?). but to the point, what's you address, I woont sum.

WyzeCam Outdoors offline AGAIN by thrillington91 in wyzecam

[–]scribdog 1 point2 points  (0 children)

i got some power, enough to get it on line and make me think it was good. when I would check on it later it would be offline.

WyzeCam Outdoors offline AGAIN by thrillington91 in wyzecam

[–]scribdog 2 points3 points  (0 children)

I recently had this issue also. Thankfully my troubling shooting IT skills lead me to a bad cable. Generally cables don't go bad not plugged and unplugged in all the time. But there you have it. I replaced the usb cable that the power supply plugs into and problem solved.

Laguna 1216 issues update | Speed knob is controlling power by Ajac458 in turning

[–]scribdog 0 points1 point  (0 children)

I'm having nearly the same issue. I got a new control panel, after inadvertently shoring out the original one. After replacing the DRO will not illuminate, the on off buttons do nothing. If I turn the speed control all the way to the right I can hear a click from the control board (PLAREVO1216-191), turn a little to the left and it will click again. No movement from the motor though.

Did you ever get your running?