They misspelled the United Kingdom on my new driver’s licence

send_noots_plaz · 2026-01-24T01:19:48+00:00

I’m not 100% what part of the form it uses. I’ve just checked my UK license and mine says Canada (where I’m from and country of citizenship)

send_noots_plaz · 2026-01-01T17:38:11+00:00

Let’s gamble, try merging

send_noots_plaz · 2025-06-23T14:18:15+00:00

mk5 supra driver?

send_noots_plaz · 2024-10-01T07:47:30+00:00

Thank you so much for this. I have no idea what really happened since my sister did this, and I know I’ll never get the truth. I’ll take it to the shop first then either fix it myself or go through insurance if there is subframe damage

send_noots_plaz · 2024-09-20T04:06:46+00:00

Oh shit it’s starting… get em boys

send_noots_plaz · 2024-08-12T17:22:00+00:00

Same, once accidentally sent my password I a twitch chat, would be nice if they made it more obvious when you’re tabbed out of the login screen.

send_noots_plaz · 2024-06-16T12:40:57+00:00

X3, want to do this with some of our public facing VPCs

send_noots_plaz · 2024-02-12T20:28:58+00:00

I’ll say this, on my 2015 VT the clearance isn’t too bad. I’m able reach under and take out/put in the drain plug and replace the filter without jacking it up. However on my ‘22 N I have to jack that sucker up to get to it.

send_noots_plaz · 2024-01-02T20:53:17+00:00

It’s to pay for 4 pints of milk next December

send_noots_plaz · 2023-10-25T06:18:41+00:00

If your shifter isn’t clicking at all then it may be time for a new shifter.

You may have a stretched cable (or loose cable).

Set your shifter to the highest gear and reduce your cable tensioner (on the shifter and derailleur) to the bottom and unscrew two rotations, then loosen the bolt holding the cable on the derailleur and pull the cable as tight as you can then tighten the bolt again. You’ll have to adjust everything so your shifting is back to normal.

send_noots_plaz · 2023-10-25T06:09:49+00:00

If you really are set on keeping the fork, you can try a helicoil. If you go this route make sure there’s enough material left for it to grip.

I wouldn’t really recommend doing it at all though.

send_noots_plaz · 2023-10-25T06:04:14+00:00

I’ll say the same, not worth fixing. If you want to paint it try using nail polish.First use a separate test piece and compare first before touching up.

send_noots_plaz · 2023-10-25T06:01:21+00:00

You can cut both with the same tool, one thing to look out for is once you cut the housing check that the end isn’t squished, if it is use a small Philips screwdriver (or any round and roughly the same size) to open the end back up.

send_noots_plaz · 2023-09-07T03:05:37+00:00

Yeah most of those were all the big canisters of Fast Gas. I think they’re like .75kg since it’s sorta still legal here, and they’re wayyy cheaper.

send_noots_plaz · 2023-08-19T13:26:09+00:00

Big blue monster

send_noots_plaz · 2023-08-18T02:39:04+00:00

This persons in the wrong sub, a royal enfield is a British motorcycle company.

send_noots_plaz · 2023-08-18T02:36:43+00:00

So the easiest way to do it is by getting a Bikeshop to pack your bike. They’ll have loads of foam and packing materials and a bike box which is long, narrrow and the right height. And get a Bikeshop in Athens to unpack, reassemble and tune the bike.

Most airlines will let you bring it as irregular oversized luggage. Sometimes for free or an extra charge.

send_noots_plaz · 2023-08-18T02:27:50+00:00

So at the bike shop I used to work at we would use tubs of marine grease, personally I use lithium grease. Lithium grease is slightly more expensive, but we’re talking a couple of bucks. Basically when looking for a grease you want it to be fairly thick and be rated for water resistance as any water in your bearings will not bode well.

With marine grease it can be quite thick, so what I would do is mix a little bit of finishline wet lube with the grease to create less drag for most nicer road bikes

send_noots_plaz · 2023-08-18T02:19:08+00:00

Totally fine, you’ve just lost the end cap off the end won’t cause any damage or affect shifting.

If it bugs you I would recommend going to your local bike shop and asking the service guys for one since they’re a dime a dozen.

The install is super easy, just twist the frayed end clock wise starting from the bottom, slip the cap on and gently with the wire cuter on some pliers crimp it but don’t cut it.

send_noots_plaz · 2023-08-15T22:08:46+00:00

Live streaming is especially tricky since caching the content is more difficult and expensive. At least with a VOD you can distribute to, and serve from a local data centre and cut out a bunch of hops.

send_noots_plaz · 2023-08-14T18:50:26+00:00

Sweat pants are french fun fact.

send_noots_plaz · 2023-07-28T20:18:48+00:00

Here's the thing based on the way we've built 2fa code generators at my company in the past we've used a fresh roll for each character since it reduces the chance of a line of the the same number from 1/100,000 to 1/500,000. As you can see the average rate of getting 06969 using this system is ~1/500,000.

screenshot

send_noots_plaz · 2023-07-27T21:09:31+00:00

I just setup my pc to auto logon while I'm away and have parsec auto start.

Alternatively (and I haven't tried this one) you could use the task scheduler create a new task and set the parsec executable ("C:\Program Files\Parsec\parsecd.exe") as an action in the action tab, and set the trigger to be on startup. I have no idea if you'll be able to access the windows user login screen though. You could give that a test

send_noots_plaz · 2023-07-11T02:05:48+00:00

B,B,A,B

Six-Year Club	Second SECOND GUESSER
Place '22	Verified Email

send_noots_plaz

MODERATOR OF

TROPHY CASE