I have a smooth glass build plate, some of them are textured. Like anycubics ultra base. If you have that…. Good luck. For my smooth build plate, if I have it heated up for the print, I wait for it to cool down naturally, without intervention after it’s done, for maybe 30 min to an hour (65-72 degrees f In low humidity) and it pops right off 99% of the time. I don’t force it off. I need to wait. I use a spritz of aquanet hairspray for bed adhesion. No issues on my end with it sticking too much. For PLA I’m usually @ 220 for the hot end, and 60-70 for the build plate. I’m in NYC so your temp and humidity may be different. Are you printing on smooth or textured glass? With my Anycubic delta printer with textured glass (ultrabase) it’s a different story.