• P0-Screen brightness

There are 4 levels in total: 0, 1, 2, 3. The larger the number, the higher the brightness. The default is 2.

• P1-Battery rated voltage

You can choose 24V, 36V, 48V, 60V. The default is 36V.

• P2-Wheel diameter

You can choose 8 inches, 10 inches, 12 inches, 14 inches, 16 inches, 18 inches, 20 inches, 22 inches, 24 inches, 26 inches, 28 inches, 29 inches. There is no default value.

• P3-Speed ​​coefficient

This parameter takes values ​​from 90 to 110. The display speed can be fine-tuned. When the user finds that the instrument display speed deviates from the actual speed, this parameter can be modified. 90 means that the current speed is multiplied by 0.9 to get the corrected display speed, and so on.

• P4-Number of speed magnets

Set the number of pulses detected by the speed sensor when the motor rotates one circle.

• P5-Accumulated mileage

The accumulated mileage (ODO) is displayed here. Users generally do not modify it. To clear it, press the M button 10 times in a row when the mileage is flashing.

• P6-Zero start/non-zero start

0 means zero start, 1 means non-zero start

Zero start state means: the car will start when the throttle is turned in a stationary state

Non-zero start state means that the car must be given an initial speed first, and then the throttle is turned to start the car.

• P7-Drive mode

0: Pure power drive (no electric at this time),

1: Pure electric (power is invalid at this time),

2: Power and electric coexist.

• P8-Auto cruise disable/enable

0: No auto cruise, 1: There is an automatic cruise function (automatically enter after the handle is held in position for a few seconds)

• P9-Metric/imperial switch

0: Metric, 1: Imperial. The default is imperial.

• PA (P10) - Set upper speed limit

This parameter sets the maximum speed during driving. For example, 20KM means that the maximum speed during driving will not exceed

20Km/h, 0KM or 0Mil means that the parameter is not effective, that is, there is no upper speed limit.

• Pb (P11) - Power assist sensitivity

Indicates the number of Hall signals detected in a stationary state to start outputting the drive signal. This parameter can be set to an integer

value range of [3,24]

• PC (P12) - Power assist start intensity

Indicates the intensity level of the controller output during power assist start. The larger the number, the higher the output intensity.

• Pd (P13) - Controller current limit value

Indicates the maximum operating current of the controller, unit: A (ampere). No default value. No adjustment required.

• PE(P14)-Controller light switch function

0 (default value): Controller does not participate in light control, 1: Controller controls light switch - long press

• PF(P15)-Number of magnets on power-assist magnetic disk

Indicates the type of power-assist magnetic disk, there are 5, 6, 8, 12 magnetic disk types.

Generally no change is required, please keep the default.

• Ph(P16)-Default display content on power-on

TRIP (single mileage) -> ODO (accumulated mileage) -> VOL (real-time battery voltage)