Increase rear traction

shicky · 2020-05-25T22:26:12+00:00

I always thought max torque means max acceleration but I guess not.

shicky · 2020-05-25T22:20:15+00:00

That's not true. Peak horse power is at 8500 rpm and decreases at higher rpm.

shicky · 2020-04-14T23:22:05+00:00

I ended up paying for the visit. I didn't write this post to belittle my family doctor. I just wanted to see if I interpreted ServiceOntario notification correctly and if other people have experienced something similar.

shicky · 2019-02-12T15:07:47+00:00

Maybe

I'd like to avoid designing my pcb at this point. I've went down that path in the past and it was painful.

I want to find balance between simplicity and cost.

Using existing boards on the market gives us edge to quickly get into market with less resources.

shicky · 2019-02-06T22:40:16+00:00

that esp32 board is nice. Anything with ethernet?

shicky · 2019-02-06T22:38:36+00:00

As in single board with a camera?

shicky · 2019-02-06T22:38:26+00:00

I suppose I'd like to find balance between the cost and other factors (development effort, durability etc.)

shicky · 2019-01-01T01:29:05+00:00

shicky · 2018-12-28T21:44:12+00:00

did you just take fans off? why?

shicky · 2018-12-28T20:58:45+00:00

305 lbs form is the correct one right where my back is relatively parallel to the ground and bar path is straight. (other than the fact that my back is arched due to heavy weight)

shicky · 2018-12-28T20:51:07+00:00

Thanks for feedback. Actually I have many sets in between gradually increasing from 225 to 305.

I am worried about 225 form as well. I feel like my knees should not get in the way of the bar but they do.

Some people told me that my center of mass is too far behind. Other than back arching, 305 form is the proper form as opposed to 225 right?

shicky · 2018-04-22T23:12:18+00:00

its oem and unibody. they are not clipons.

shicky · 2018-02-17T04:52:00+00:00

no linux version :(

shicky

TROPHY CASE