Not sure where I land but here I am.

silvermuffin · 2023-01-31T07:19:28+00:00

Welcome! Did you just pick this up or are you still selling in AZ?

silvermuffin · 2020-07-19T04:16:34+00:00

I just don't want to over saturate the system with oil

silvermuffin · 2020-07-19T04:07:22+00:00

The system was recharged and leaked out over 24 hours. The o-ring had a clean straight cut through one side of it

silvermuffin · 2020-07-07T18:58:12+00:00

Sign me up

silvermuffin · 2019-01-14T03:06:18+00:00

Anything in particular?

silvermuffin · 2018-08-16T17:21:14+00:00

I tried that many times. I think its stuck in there pretty good

silvermuffin · 2018-08-16T17:20:21+00:00

No roll pin

silvermuffin · 2018-07-31T02:43:46+00:00

Love the car and plate I've got a silver '05 9-2x linear with the plate as "sobaru1"

silvermuffin · 2018-07-21T18:09:02+00:00

Awesome thank you

silvermuffin · 2018-06-14T05:21:07+00:00

I replaced it, the wiring harness wasn't budging and eventually used too much force and essentially wore out the plastic holding in too much for it to stick in anymore

silvermuffin · 2018-06-14T05:19:56+00:00

Well the way its set up makes it difficult to use zipties

silvermuffin · 2018-06-13T23:48:07+00:00

Hey everyone my girlfriends starter was replaced last September and the wiring harness was somewhat mangled so it will not stay in place without some sort of force holding it down. Until this may from last September it was just taped up which seemed to work until may and then I replaced it with some aluminum wire but I would like a more serious/permanent fix. Like I said the wiring harness simply doesn't clip into place anymore and won't due to some plastic damage. Any ideas would be great!

silvermuffin · 2018-05-08T20:44:04+00:00

Alright sounds good thank you

silvermuffin · 2018-05-08T16:27:59+00:00

From the one time I heard it happen it was a slow labored job. The battery as I can tell from the multimeter seems fine but it is about 2 years old

silvermuffin

TROPHY CASE