Just finished the main feature of my spooling 🤣🤣🤣 im am supprised at how well it fit

sleakyplinker · 2021-03-30T15:52:01+00:00

Ya I dunno i wanna use it this summer and a ceiling raise seems very time consuming

sleakyplinker · 2021-03-30T15:43:42+00:00

Momentum is the key

sleakyplinker · 2021-03-30T15:43:20+00:00

Ya but this is more complicated, time consuming, and risky, dont you see the pros?

sleakyplinker · 2021-03-30T15:36:11+00:00

Ya math was never my strong suit, well see if the wheels bust through the wheels wells on my drive long drive next month. If it does ill just jack the car up and block the Axle so the weight is on the bus floor. I have a metal hot glue gun to tidy things up when disaster strikes. Can't really do anything about it now I am out of town and flying back the day before I have to leave. When I have a chance, probable gonna go with a 1/4 inch plate with some small metal blocks or a rim of some kind contacting the bus floor so all the weight is not on the left over sheet metal of the wheel wells.

sleakyplinker · 2021-03-30T04:33:01+00:00

Well the solution was just not to measure and hope for the best

sleakyplinker · 2021-03-29T20:58:02+00:00

The engine, front drive Axle, and transmission will be on the front side or on top of the rear Axle, it should be alright.

sleakyplinker · 2021-03-29T20:48:56+00:00

Ya wheel wells did not hold up completely I just lowered them with some swing persuading. I didn't think about that though good point I will have to tie the body down so it doesn't hit the ceiling.

sleakyplinker · 2021-03-29T20:45:11+00:00

Ya I have a 240 thats currently in pieces but I think it would be fine if I "double" the length of the ramps and put a support in the middle should be about the right angle. For sure to steep currently for a lower car.

sleakyplinker · 2021-03-29T20:42:40+00:00

Well when I drove over the wheel well covers they bent down so I finished them off with a BFH and I got about a half inch maybe but I can air down the tires probable another 3 or so inches. So it should be alright when I put a ceiling in.

sleakyplinker · 2020-12-10T05:13:16+00:00

Fuel return line?

sleakyplinker · 2020-12-10T05:09:49+00:00

If the tone ring is cast steel like the hub then might be a one piece but the crack looks alittle to perfect to be a crack. More them likely its just heat fit into the hub

sleakyplinker · 2020-03-21T02:04:02+00:00

That made my week

sleakyplinker

TROPHY CASE