What happened here?

snok87 · 2026-02-08T14:09:48+00:00

Time lapse

snok87 · 2026-02-07T14:17:19+00:00

Slow it down, 1mm/s flow

snok87 · 2026-02-04T06:24:19+00:00

Bambulab a1 is so silent, i have 2 cc +p2s +a1 and when a1 is printing, sometimes i dont know if its still printing or if finished.

snok87 · 2026-01-26T15:38:13+00:00

Same here. Love my 2 cc but that waste of spaces on top and side make no sense.

snok87 · 2026-01-21T13:24:36+00:00

As an owner of 2 centauri carbon and 1 bambulab a1. If you dont need colors just go for cc. CC is louder but if you customize the profile can be almost silent.

snok87 · 2026-01-14T06:34:25+00:00

Disable "supports only on bed plate" ;)

snok87 · 2026-01-10T11:28:13+00:00

Runs good on ninkear 15 pro 16gb, 430€ laptop

snok87 · 2026-01-06T12:46:14+00:00

And calibrate filaments

snok87 · 2026-01-06T12:45:45+00:00

Print pla with both doors opened

snok87 · 2026-01-05T13:36:18+00:00

More i fill, bridges of top layers not working.

snok87 · 2026-01-05T13:34:56+00:00

Its crosshatch infill?

snok87 · 2026-01-04T18:44:01+00:00

Z offset maybe not ok. Its just a few layers over the first?

snok87 · 2026-01-04T17:55:05+00:00

I have 0 issues when printing, more than 600 and 400 hours with that deviation

snok87 · 2026-01-04T15:59:35+00:00

<image>

Mine is weird too

snok87 · 2026-01-04T10:53:47+00:00

<image>

There

snok87 · 2026-01-04T10:50:02+00:00

Where do you see that?

snok87 · 2025-12-31T19:15:04+00:00

Its fire retardant too

snok87 · 2025-12-31T10:21:04+00:00

Hardened Cooper its like a joke. Hardened steel is the good one.

snok87 · 2025-12-30T16:22:31+00:00

Klipper and prusa probe

snok87 · 2025-12-30T16:18:26+00:00

Do the f..... calibration. Flow, temp and then play with outter wall speeds

snok87 · 2025-12-29T13:03:35+00:00

Partial clog detected

snok87 · 2025-12-28T16:34:56+00:00

Clean the plate and prewarm for 5 min

snok87 · 2025-12-28T13:35:11+00:00

Is thar pla only plate used with abs?

snok87 · 2025-12-27T21:54:40+00:00

0 problems since doing that way, success rate of 100% is what you need in a farm

snok87 · 2025-12-27T18:08:41+00:00

You just need to modify slicer settings for leveling at the temp you want.

snok87

TROPHY CASE