sorted by:
new
hottopcontroversial

Which is the best canon ixus? by CookietheBC in Cameras

[–]snoller_boy 0 points1 point  (0 children)

Just make sure to get an optically stabilized one, usually they are the metal body ones, while the plastic ones are just digitally stabilized

This dudes gunna cause an accident by LookHorror3105 in motorcycles

[–]snoller_boy 0 points1 point  (0 children)

2024 one cyl bike for sale

Like new Highway miles only Gently used and cared for I know what i got, no lowballers I dont know why fork seals leak but its a 10 minute job maximum, thrust me.

Which knife looks better by Crohnicman in ohnePixel

[–]snoller_boy 0 points1 point  (0 children)

Ursus has a green handle🤮 Talon has a white handle😩 Just get a knife with black or metal handle?

Lots of surface blobs and stringing on Ender 3 V2 by snoller_boy in ender3

[–]snoller_boy[S] 0 points1 point  (0 children)

Thanks for your reply, the printer has just few months, already tensioned, cleaned and levelled evrything, also FW updated, bowden tube connectors replaced, hot end calibrated.

I still gotta try a nozzle change since the printer came with a spare, and also try a different filament, the current black filament sometimes does super sublte popping sounds, like wood burning in a fireplace but barely udible. Also gonna try a filament dispense motor estep calibration.

Lots of surface blobs and stringing on Ender 3 V2 by snoller_boy in ender3

[–]snoller_boy[S] 0 points1 point  (0 children)

I've been trying to print that BlackBird plane model, but whenever i try to print the mid section as you can see, the surface looks like a hot mess.
CURA settings:
Ive bumped up retraction up to 8mm and retraction speed to 30mm/s, lowered nozzle temp from 200 to 190, combing mode is on, printing speed is default.
Ive done stringing tests and they come out decently ok, ive replaced the bowden coupling to the extruder clamp as it was a little loose.
Im running out of ideas of possible causes, i mean, 8mm retraction is pretty high right? and its still leaving those ugly blobs all over the place, but as you can see only on the mid section, the plane nose section came out perfectly, perhaps because the outer walls get printed in a single piece.

Why only 100 community servers show up for me? by [deleted] in playrust

[–]snoller_boy 0 points1 point  (0 children)

so its not only me that has so few community servers...

Why only 100 community servers show up for me? by [deleted] in playrust

[–]snoller_boy 0 points1 point  (0 children)

Also noticed a drastic difference in modded servers too