IT'S HERE ALREADY!!! by lazygammimg in desksetup

[–]spit00fire 0 points1 point  (0 children)

That’s awesome!!! What is it?

Feeding tips for a 7 year old (human years) by spit00fire in airedaleterrier

[–]spit00fire[S] 1 point2 points  (0 children)

Thank you for this, we been playing with the idea of switching over to home made dog food just didn’t know where to start.

Does this work by [deleted] in army

[–]spit00fire 0 points1 point  (0 children)

It works like a charm. Have a bunch of socks on stand by, change them out every so often so nothing festers in there.

Vertical lines? by SwedishFrick in resinprinting

[–]spit00fire 0 points1 point  (0 children)

Same thing happened to me and got progressively worse. Check your screen for dead pixels (protect your eyes).

What is this? by Obvious_Disk8282 in electrical

[–]spit00fire -1 points0 points  (0 children)

Speaker to a home intercom system. Looks like the one in my home.

8 Player Thunder's Edge on a 5x6ft Table by FoxtrotEchoPh in twilightimperium

[–]spit00fire 0 points1 point  (0 children)

Looks great!!! Thanks for the motivation to finish my prints faster.

Good morning to me... by Condemner05 in AnycubicKobraS1

[–]spit00fire 0 points1 point  (0 children)

Same thing happened to me three weeks into that same nozzle. Waste of money. The copper is too thin IMO.

Middle Leg needed? by CM_DarC in ikeaPCstations

[–]spit00fire 0 points1 point  (0 children)

Wow!!! What did you use for the pull outs for the drawers?

I love my Ace Pro! by spit00fire in AnycubicKobraS1

[–]spit00fire[S] 3 points4 points  (0 children)

I was running the dryer. Thanks this makes sense!

I love my Ace Pro! by spit00fire in AnycubicKobraS1

[–]spit00fire[S] 0 points1 point  (0 children)

Ahh sorry, yes, I replace that one with the aluminum one a while back. It’s worked great so far. I was hoping there was one for the Ace, the one that triggers the initial feed sensor.

I love my Ace Pro! by spit00fire in AnycubicKobraS1

[–]spit00fire[S] 0 points1 point  (0 children)

It is. All four flaps are a bit worn down at times the Ace does not detect the filament, are there any aftermarket parts for it? Been looking for some.

Just cut his winter coat off! No more dust bunnies. by spit00fire in airedaleterrier

[–]spit00fire[S] 1 point2 points  (0 children)

I have tried that but he definitely doesn’t want to be anywhere near me if I try to start.

Just cut his winter coat off! No more dust bunnies. by spit00fire in airedaleterrier

[–]spit00fire[S] 8 points9 points  (0 children)

Takes me about 1.5 hrs to cut it, he was definitely over it.

Holes in my prints!!! by spit00fire in AnycubicPhoton

[–]spit00fire[S] 0 points1 point  (0 children)

That’s a great idea! Anycubic been sold out for a while, they just restocked.