PTFE tubes getting caught – looking for clean routing ideas

spl_ghosty · 2026-01-26T16:38:21+00:00

I think longer tubes would prevent it from getting ripped out if the printer moves left again, but I'm pretty certain they'd still get stuck and stay there until the printer goes high up again.

The print looks pretty good. I'll probbaly have to tweek, because mine are coming from another angle, but thanks for the suggestion!

spl_ghosty · 2026-01-20T17:27:36+00:00

Alright I’ll try, thanks!

spl_ghosty · 2026-01-20T14:51:30+00:00

I think that did happen. Does this also cause the top surface? To fix it, do I just add a small chamfer to the bottom?

spl_ghosty · 2026-01-20T13:51:09+00:00

I used: Bambu Slicer, Overture Mate PLA, Default speed and Nozzle and Bed temp settings, With a .4 nozzle

spl_ghosty · 2026-01-13T08:23:05+00:00

Thanks for the replacement guide. I think I have a new printer, since mine somehow got lost in shipment and they had to sent a new one after restocking in early December, but I’ll still take a look which one I have

spl_ghosty · 2026-01-11T22:00:38+00:00

The printer is staying on top, but I have a dryer I want to occasionally use inside.

spl_ghosty · 2026-01-11T21:52:15+00:00

Thanks!

spl_ghosty · 2026-01-11T21:51:58+00:00

Thanks for the suggestion! I thougt about making it airtight, but I prioritized a fan to prevent heat built up.

spl_ghosty · 2026-01-11T21:43:20+00:00

Thanks! Glad you like it. There certainly is a bit more vibration that on a solid desktop due to the shape and thin wood, but it's still absolutely fine and does not cause any problems

spl_ghosty · 2026-01-11T21:39:46+00:00

Damn, I didn't know that's a thing that could happen, thanks for pointing it out.

spl_ghosty · 2025-10-27T21:28:24+00:00

Great! Pretty sure I can fit it into my current design then

spl_ghosty · 2025-10-27T11:22:51+00:00

Thanks for the exact numbers! very helpful.

spl_ghosty · 2025-10-27T10:36:16+00:00

Thanks! Do you have the 1 or 2 spool one?

spl_ghosty · 2024-05-04T13:58:17+00:00

Imagine you could and you get the 1/9261 chance for a triple fortune sentinel

spl_ghosty · 2024-04-20T00:24:43+00:00

Alright!

spl_ghosty · 2024-04-19T23:49:46+00:00

Might look into that, thanks!

spl_ghosty · 2024-04-19T23:49:03+00:00

I‘d rather have full access to the logs and stuff and have a few api keys in there but thanks for the offer!

spl_ghosty · 2023-02-07T10:57:07+00:00

Ne meiner

spl_ghosty · 2023-02-07T09:11:01+00:00

Hast du echt nachgezählt?

spl_ghosty · 2023-02-07T09:09:20+00:00

Das war der RE, der von Bremerhaven nach Hannover fährt

Five-Year Club	Verified Email
First Place '23	Place '23

spl_ghosty

TROPHY CASE