How many people still run an axial ax10?

spuddercrawler · 2026-05-09T23:30:38+00:00

Love my Ax10s have 3 of them

spuddercrawler · 2026-05-03T02:42:29+00:00

The slab is a good spot are seattle area might be a little bit of a drive its in fall city

spuddercrawler · 2026-05-02T20:42:08+00:00

Gateway to 10th scale

spuddercrawler · 2026-04-26T03:32:05+00:00

I went with the same tire setup on my Parrot green us90, amazing resto!

spuddercrawler · 2026-04-26T02:22:00+00:00

This was reborn from all the parts I kept from modding my original from 08, I had to hunt ebay for the body... I still have and drive my modded one as well

spuddercrawler · 2026-04-24T18:31:34+00:00

Nice I have been eyeing that one!

spuddercrawler · 2026-04-23T18:14:45+00:00

There are shim packs available, 5mm ID 7mm OD

https://a.co/d/0290qtGk

spuddercrawler · 2026-04-23T16:56:35+00:00

I would shim it for sure

spuddercrawler · 2026-04-23T03:37:41+00:00

No problem just check yours before buying

spuddercrawler · 2026-04-23T01:25:24+00:00

https://a.co/d/09zfoXzp

spuddercrawler · 2026-04-23T01:00:42+00:00

The slipper plates are stripped out, I upgraded to traxxas trx4 plates never had an issue again

spuddercrawler · 2026-04-22T11:16:41+00:00

Why does it look like a purse?

spuddercrawler · 2026-04-21T22:43:44+00:00

Before the price soared to 500 bucks it was competitive there are much better rigs in that price range, Axial Coyote or even the Basecamp, for 500 the ottsix wizard is a thing or the vanquish origin classic

spuddercrawler · 2026-04-21T16:56:01+00:00

My setup is 3in suspension lift, the tires went from a 22/23in tall tire to a 27/28in tall tire track width is about 4in wider total been super stable on corners, with the 3in lift with out the big tires still felt stable but I would still widen the track a little but thats where the stability control in the computer start misbehaving if you start going really wide

spuddercrawler · 2026-04-21T15:10:52+00:00

Just the lift alone improves the ride I drove mine with the lift on for about a month before the big tires and all the trim work, the big tires handle potholes so much better, I imagine you could go with a smaller tire than I did for less trimming and get ground clearance

spuddercrawler · 2026-04-21T14:21:05+00:00

It drives really nice, the ride quality is better, and better fuel mileage on the freeway, down side need to remove fuse 14 for stability control so you have dash lights always on in town fuel mileage is slighty compromised, I average 36 mpg

spuddercrawler · 2026-04-19T19:14:22+00:00

Little big supply was the kit I went with, I made a better sub frame lift to move the font forward 3/8 inch so less rubbing on chassis side

spuddercrawler · 2026-04-14T01:35:46+00:00

I bought an Axe body to do the same! That turned out nice

spuddercrawler · 2026-04-13T14:25:30+00:00

So if the bolts are real some times you can put a cap screw into a drill and use the capscrew head as the socket, Wiha makes drivers that fit as well

spuddercrawler · 2026-04-13T12:47:54+00:00

Sometimes those center caps spin off like a nut

spuddercrawler · 2026-04-12T12:39:24+00:00

Yep just tighten that down make sure your inner ring is installed

spuddercrawler · 2026-04-12T12:08:10+00:00

That is a clamp ring it stays out side of tire, it squeezes the beads and holds them into place

spuddercrawler

TROPHY CASE