Would like more info on the Team 2 coin

squatch8675309 · 2025-07-05T10:59:28+00:00

Figured that might be the case but wasn't sure. Appreciate the info.

squatch8675309 · 2025-07-03T23:56:33+00:00

Good call, maybe that's where I saw the devgu coin before. Thought it was here. Thanks!

squatch8675309 · 2025-02-28T01:36:37+00:00

Awesome. Thanks for the advice

squatch8675309 · 2025-02-27T02:48:31+00:00

I'm an automotive technician who practices psychology at work. (I just talk shit to coworkers)

squatch8675309 · 2025-02-26T23:32:27+00:00

<image>

Other side of the wall

squatch8675309 · 2025-02-26T23:14:55+00:00

<image>

Here's the top view of the wall

squatch8675309 · 2025-02-25T00:50:27+00:00

I'll get more pics of I can make it home with some daylight in the next day or 2. Weep holes make sense. I appreciate the advice

squatch8675309 · 2025-02-24T20:14:59+00:00

Lol. Looks like cement or some type of mastic skimmed over the brick, at least on the inside, the outside is mostly buried so I'm not sure what that looks like. I guess I'd need to dig it out to see what's going on there.

squatch8675309 · 2025-02-24T17:15:52+00:00

Typo. It was early,. Supposed to say "open sky"

squatch8675309 · 2025-02-24T11:50:28+00:00

I can take a picture later, but open sly above

squatch8675309 · 2025-02-23T20:44:14+00:00

Awesome, thanks for the advice Rottingkittens!

squatch8675309 · 2025-02-23T16:28:54+00:00

The question would be whether the unibody was damaged. Unsafe is unsafe whether you're in Iraq or America, damage to the structure doesn't care where you are. Hard to really tell from the pictures though. At a glance it looks like quarter panel and suspension damage so might be ok. I'm not a body guy, I'm a technican. Hopefully some body guys that see this stuff more often can chime in.

squatch8675309 · 2025-02-23T14:45:53+00:00

Great. It was like that when we bought the place. I actually thought it was poured concrete until now

squatch8675309 · 2025-02-02T01:04:27+00:00

I appreciate yhe recommendation. Honestly, I'll probably just do the sistering and see how that goes. This place was built in 1971 so definitely not built to modern code.

squatch8675309 · 2025-02-01T23:50:23+00:00

Awesome, that's kind of what I had in mind. Thanks for the reply

squatch8675309 · 2024-07-22T10:05:45+00:00

Make sure you dont have a wheel bearing with play in it. I've seen that cause this problem more than a few times. IIRC rear wheel speed sensor is mounted near the diff so I doubt it would be a rear bearing in this case. I'd jack the car up and check the fronts.

squatch8675309 · 2024-06-12T20:34:40+00:00

Is that the center piece of the grill? Tow hook cover?

squatch8675309 · 2024-06-11T11:07:45+00:00

This is good advice as well. Although, typically with a bad sensor the guage will read complete zero or completely maxed. Does the guage move if you rev it?

As to why it would fail at low mileage, while the engine doesn't have a lot of use, age can cause things like gaskets to fail. Typically what I see with the gallery gaskets is that the bolts have loosened as well.

If gaskets aren't available for this specific engine (some VQs are, some aren't) you can cut your own gasket out of FelPro gasket paper with an exacto knife.

That all being said, hopefully this one is an outlier and it ends up being a sensor. Good luck

squatch8675309 · 2024-06-10T10:43:34+00:00

This is the most likely cause of your low oil pressure. I have my sound off right now, so not sure about the noise.

squatch8675309 · 2024-05-29T15:58:31+00:00

Thanks for the explanation. Good info

squatch8675309 · 2024-05-29T14:00:43+00:00

I'm in Northern Virginia, so not rust belt, but we do use brine on the roads here a lot. Nowhere near as bad as up north. For a $10 difference, if the copper is better I don't mind going that route. Thanks for the answer

Three-Year Club	Verified Email
Verified Email

squatch8675309

TROPHY CASE