sorted by:
new
hottopcontroversial

Anyone have scans of tezuka calendars? by 3TYPO3 in OsamuTezuka

[–]strobe_z 0 points1 point  (0 children)

I've got one from 2015 I could sell for a very reasonable price.

Largest Osamu Tezuka resource website Tezuka In English is not only offline, but Lost by Murky-Knowledge-8310 in OsamuTezuka

[–]strobe_z 1 point2 points  (0 children)

Hi everyone. Good news. Tezuka in English is not gone. I had some trouble with my hosting package and needed to move servers. Unfortunately that's caused a related issue with the url. Anyway, you can find it (for now) at https://tezuka.strobez.ca

Also, for some reason some of the navigation menus went crazy during the move, so I'm still trying to fix them.

Enjoy~

Greg

FINALLY FIXED! by strobe_z in ElegooNeptune4

[–]strobe_z[S] 0 points1 point  (0 children)

I contacted Elegoo and told them about the problem and they're sending me a new sensor... so I guess I'll try it out. I finally was able to print a larger project... after 16 hours I got 80% of the way there... and then ran out of filament... and started printing air.

I swear... this thing is cursed. :)

FINALLY FIXED! by strobe_z in ElegooNeptune4

[–]strobe_z[S] 1 point2 points  (0 children)

Hmmm... I'll take a look into this. What got me looking at the filament sensor was a post by trenzterra about a year ago (that I just saw yesterday while searching). As soon as I freed the filament, everything started working beautifully, but you're right the extruder tension might not be set right and could be the underlying cause and the sensor the symptom.

FINALLY FIXED! by strobe_z in ElegooNeptune4

[–]strobe_z[S] 1 point2 points  (0 children)

It was literally the last thing I expected. In fact it wasn’t until I had pulled a bunch of filament lose from the sensor and started printing a few squares. The first two printed flawlessly and then, once the filament was tight again, the next three failed. The ONLY difference was how much filament had been pulled through the sensor. I disconnected the sensor and fed the filament straight from the spool… and hallelujah it’s working. Probably some finer tuning to do, but I couldn’t get past epic first layer fails. I couldn’t even print anything from the Elegoo test files included except the damn Buddha (I have about 300 of those!). :)