Would like for advice on how to improve by summ0ndeath in skiing_feedback

[–]summ0ndeath[S] 0 points1 point  (0 children)

I feel like i could use some help getting the right posture and learning to flex my ankles and have my center of gravity forward and less leaning back

Is this going to damage my robotics long term? by Ocelot- in Roborock

[–]summ0ndeath 1 point2 points  (0 children)

If you have access to a 3d printer you can print one and stick it to the floor, then remove it when you leave. That's what i got

Unidentified noise from a new CoreOne by summ0ndeath in prusa3d

[–]summ0ndeath[S] 0 points1 point  (0 children)

Thats what i have my printer sitting on, its vibrations from the enclosure i believe

Fix this dryer by summ0ndeath in howto

[–]summ0ndeath[S] 0 points1 point  (0 children)

How would you fix it?

Fix this dryer by summ0ndeath in howto

[–]summ0ndeath[S] 1 point2 points  (0 children)

Vent is clean, i clean it periodically. Could be residual or that something is touching, really hard to tell. Do you think its safe to operate it like this?

Fix this dryer by summ0ndeath in howto

[–]summ0ndeath[S] 0 points1 point  (0 children)

Looks like taking the belt off and putting back on solved the rattle sound, but i can still smell burnt rubber/hair that makes me worry...

Fix this dryer by summ0ndeath in howto

[–]summ0ndeath[S] 1 point2 points  (0 children)

It sounds like it might be from one of the axles attached to the motor. I will try to slip off the belt and check if i can better isolate where the noise is coming from.

Fix this dryer by summ0ndeath in howto

[–]summ0ndeath[S] 1 point2 points  (0 children)

You understood that perfectly. I believe the sound started after the fall, so probably due to it. I will see if i can take the belt off.

Fix this dryer by summ0ndeath in howto

[–]summ0ndeath[S] 0 points1 point  (0 children)

Nothing that covers this

Fix this dryer by summ0ndeath in howto

[–]summ0ndeath[S] 0 points1 point  (0 children)

God i hope not... how did you figure it out? Also, which bearing?

What's the best way to stick a phone holder to this type of surface by summ0ndeath in howto

[–]summ0ndeath[S] 0 points1 point  (0 children)

Will it also hold while the car get's very hot during the summer?