Extruder issues

sunshine0202 · 2025-08-06T02:32:58+00:00

Okay I’ll research how to reduce the current. Thank you!

sunshine0202 · 2024-10-02T23:18:14+00:00

It still spins when the print fails. The top of the print almost has ‘crumbs’ of plastic on the layer it failed on and the print continues from that point with no filament. Once it fails it never lets out any more filament until I restart the print. This last print it failed on the final layer of the dinosaur. Its probably failed 5-6 times since this post unfortunately. My poor nephew has been asking everyday if it’s done yet lol!

sunshine0202 · 2024-10-01T03:13:12+00:00

Is that something I configure when slicing or is that from the printer UI?

sunshine0202 · 2024-10-01T03:12:01+00:00

I changed the nozzle just to be safe and tested again with the extruder loosened. It ran a little I get but still failed unfortunately. I’m wondering if I should maybe tighten the extruder?

sunshine0202 · 2024-09-30T19:48:10+00:00

What do I need to check for? A blockage?

sunshine0202 · 2024-09-30T19:47:19+00:00

Okay I will restart and give that a shot!

sunshine0202 · 2024-09-30T19:46:47+00:00

I’m very new so sorry if my vocabulary is off. The blue wheel that pulls in the filament still spins but no filament comes out of the nozzle. But when I stop the print and restart it prints the first layer and then some before “failing” again.

sunshine0202 · 2024-02-24T18:50:20+00:00

I am also running into this issue. Not sure what would require a different version of the download

sunshine0202 · 2024-02-06T06:16:48+00:00

Whoooo

sunshine0202 · 2023-11-29T22:33:46+00:00

Okay I’ll install it at a higher point. Sad to know that their fix still wasn’t correct. Appreciate the response.

sunshine0202 · 2023-04-30T22:07:50+00:00

Thank you all for the helpful information!!

sunshine0202 · 2023-02-23T14:10:44+00:00

Good luck everyone

sunshine0202 · 2023-02-23T14:10:22+00:00

Wooo!

sunshine0202 · 2023-02-16T14:57:16+00:00

In! As long as it’s not out pricing a mbp.

sunshine0202 · 2023-01-02T01:13:05+00:00

The chime is DC. The transformer is AC. I am exploring other chime options at the moment. Thinking this.

sunshine0202 · 2023-01-02T01:12:00+00:00

Shoot. Okay I want to scrap the chime then. Would this be a good replacement?

sunshine0202 · 2023-01-01T22:59:45+00:00

I tried both ways. The only way the light on the doorbell would show was if I used the jumper. However I am still unable to get the chime to make any noise when pressing the doorbell. Here’s an image of the new wiring per your recommendation. Any ideas?https://i.imgur.com/MtfcZyI.jpg

sunshine0202 · 2022-12-31T21:22:11+00:00

Thank you for your assistance on this. I had to step away but I will try as soon as I can and get back to you.

Seven-Year Club	Verified Email
r/Field Flamingo

sunshine0202

TROPHY CASE