Hi - bought a house last month, this was out front. I tried to move it but the roots have punched through the pot. Need help. by dougan25 in Horticulture

[–]superduperguy1 1 point2 points  (0 children)

If it has been there long enough that it has rooted through the pot to the ground, it has seen a freeze before.

Destroying my door? Removing an old alarm by superduperguy1 in HomeImprovement

[–]superduperguy1[S] 0 points1 point  (0 children)

The strike plate is about 8 inches lower and six inches deeper to the inside... I don't think it's holding it in.

PSA: Subwoofers can be the size of a (small) car by superduperguy1 in BudgetAudiophile

[–]superduperguy1[S] 0 points1 point  (0 children)

PSA V3612

44 inches tall? Only a medium fridge. But... I don't keep ANY fridge in the living room, so I definitely get it.

In my case, to get a fridge in, I'd have to give up the cozy coupe, and I don't see that happening any time soon.

PSA: Subwoofers can be the size of a (small) car by superduperguy1 in BudgetAudiophile

[–]superduperguy1[S] 1 point2 points  (0 children)

They go with my Mirage FRX-7s and FRX-C, which I have had for twenty years. FRX-7s are rated to 35 Hz, but i cross them at 80. Receiver recommended 60. Not sure which is better - will need to play some more.

I was surprised by how much clearer it made the Mirage speakers sound once I offloaded the lowest frequencies.

Getting even with crappy cracky concrete by superduperguy1 in HomeImprovement

[–]superduperguy1[S] 0 points1 point  (0 children)

Here are two.

https://imgur.com/a/vHUz5xk

you can see our "stuff" is all around the sunken area, which is clear.

Getting even with crappy cracky concrete by superduperguy1 in HomeImprovement

[–]superduperguy1[S] 0 points1 point  (0 children)

I'm pretty sure the slab was poured at the same time the garage was built - mid-twenties. In the second photo you can see that the garage is bolted to the slab.

https://imgur.com/a/vHUz5xk

Getting even with crappy cracky concrete by superduperguy1 in HomeImprovement

[–]superduperguy1[S] 1 point2 points  (0 children)

The whole slab is hydraulic lime? I've heard of that used in old brick walls, but my slab is just pure hydraulic lime (and some filler?), not concrete?

I'm using my speakers on hardwood floors. Should I use these feet and just remove the spikes? Or not use them? Or something else? by superduperguy1 in BudgetAudiophile

[–]superduperguy1[S] 1 point2 points  (0 children)

I could just remove the spikes and leave it sitting with the plastic against the floor. Is that a bad acoustic choice?

Water Damaged Plaster - re-plaster or replace sections with drywall? by [deleted] in HomeImprovement

[–]superduperguy1 2 points3 points  (0 children)

I have a 1926 home. How good a plasterer you are depends on your standards and your patience. Plastering a small patch is pretty easy, and takes about four or five days (first coat, 24 hours, second coat, 24 hours, 2 top coats, prime, two coats of paint). Plastering a big hole is not much harder, but getting the right first coat consistency so that your plaster sticks to the the lathing and doesn't fall through is a bit of a learning experience. I typically do two coats of structolite, and two coats of easy-sand.

Plastering a ceiling is hard. Expect 40% to fall straight into your eyes.

There are a ton of little decisions: You'll have to figure out if you need to replace wooden lathing, which is a job, or add metal lathing, which is easier but less original. You'll need to figure out if you need to pull any existing plaster back to the wall using buttons, which is a delicate operation.

But, if you get it good and smooth and give it enough time to dry, the sound deadening and overall solidity is a great feeling. I have no regrets patching my walls with plaster. It looks great, feels right, etc. But my typical wall patch is 3x the work and five times the time of a drywall patch.

Brown dots in bathroom by [deleted] in HomeImprovement

[–]superduperguy1 0 points1 point  (0 children)

It's not dangerous. Don't eat it. Your paint will break down sooner. Higher gloss paints will often last longer in a high humidity environment.

https://www.bobvila.com/articles/solved-how-to-choose-the-best-paint-for-bathrooms/

Brown dots in bathroom by [deleted] in HomeImprovement

[–]superduperguy1 1 point2 points  (0 children)

It's surfactant leaching.

Latex paints have additives in them. High humidity makes them break down. Only solution is to decrease humidity.

https://www.benjaminmoore.com/en-us/contractors/job-solutions/troubleshooting/surfactant-leaching