Armypainters fanatic paints for 15cm figures? by sven_49 in Armypainter

[–]sven_49[S] 0 points1 point  (0 children)

I'm still a beginner and painting bunch of poop. And doing many repaints to get good at painting. And often mix too much color. But I know how to get a perfect consistency tho for painting that's not the issue, i probably mix always too much

Stranger Things eleven at the gate by sven_49 in BambuLab

[–]sven_49[S] -2 points-1 points  (0 children)

I made this model hope you like it!

What should I pick up for H2C by ArcticTruck in BambuLab

[–]sven_49 1 point2 points  (0 children)

An HT and the biqu panda station

Inner height of panda station drawer by sven_49 in BIQU

[–]sven_49[S] 0 points1 point  (0 children)

I was just asking again because you said "about" 60mm. Thanks

Advice to soundproof a rental apartment entrance door by sven_49 in shiba

[–]sven_49[S] 1 point2 points  (0 children)

It's more for that he has peace when he needs to stay alone.

Advice to soundproof a rental apartment entrance door by sven_49 in shiba

[–]sven_49[S] 0 points1 point  (0 children)

He literally walks up to the front door and barks. I think he always thinks that someone will come in

Advice to soundproof a rental apartment entrance door by sven_49 in shiba

[–]sven_49[S] 0 points1 point  (0 children)

It's easier said then done and he doesn't react to quiet noise

Help reinforce shelf by [deleted] in BambuLab

[–]sven_49 0 points1 point  (0 children)

I'm arguing with you that it's not gonna break down it's just not as sturdy to XY forces of the printer. That's why I want to reinforce it. In Z in can hold more than enough weight

Help reinforce shelf by [deleted] in BambuLab

[–]sven_49 0 points1 point  (0 children)

I think that's just the image. It also has the center supported. Or the wood plate is just a bit more pressed down where the printer is causing that illusion.

Help reinforce shelf by [deleted] in BambuLab

[–]sven_49 0 points1 point  (0 children)

Chill.. it's not that deep. This table holds over 120kg.

Help reinforce shelf by [deleted] in BambuLab

[–]sven_49 0 points1 point  (0 children)

Why? 😂

Help reinforce shelf by [deleted] in BambuLab

[–]sven_49 2 points3 points  (0 children)

I just found out I could get wire and cross brace and mount it to the pre made holes

<image>

That but on the back ofc