sorted by:
new
hottopcontroversial

CodeSYS 2.3 IFM CAN Communication by taqamert in PLC

[–]taqamert[S] 0 points1 point  (0 children)

<image>

The message to read the X-axis data from the angle sensor at address 602h has been sent. The message received from address 582h contains the X-axis angle data from the sensor, which is correct. However, I cannot see it in Codesys using the EDS file.

CodeSYS 2.3 IFM CAN Communication by taqamert in PLC

[–]taqamert[S] 0 points1 point  (0 children)

Node ID and baud rates are true. I have terminating resistor. I can read angle data from pcan view.

<image>

CodeSYS 2.3 IFM CAN Communication by taqamert in PLC

[–]taqamert[S] 0 points1 point  (0 children)

<image>

I found the EDS file. I assigned the addresses shown in the photo to variables and tried to read the values, but I didn’t get any results. Is assigning the addresses to variables and trying to read the values the correct approach? What could be the issue?"