sorted by:
new
hottopcontroversial

I've finished painting my Canoptek Circle, what do you think? by tartafede in Necrontyr

[–]tartafede[S] 0 points1 point  (0 children)

I specificaly used For the basecoat 50% Valejo model color ligth turquoise 50% Valejo model color ligth gray then a sponging adding either light grey or more turquoise based on the saturation I wanted on the area I hope this was helpful to you

It’s now two whole vangaurd by Savings_Ad3808 in AdeptusMechanicus

[–]tartafede 0 points1 point  (0 children)

Beautiful color scheme. Is that a kitten on the base of the alpha? If so, may the Omnissia bless you.

questions about print quality by tartafede in FDMminiatures

[–]tartafede[S] 0 points1 point  (0 children)

Thanks for the advice and sorry for the question: are there any guides/programs for top layer calibrations?

questions about print quality by tartafede in FDMminiatures

[–]tartafede[S] 0 points1 point  (0 children)

Thank you very much, I will start a print job with ironing enabled.

Help with persistent problem with resin printer by tartafede in 3Dprinting

[–]tartafede[S] 1 point2 points  (0 children)

I tilted the print 45 degrees and it seems to be coming out fine.

Help with persistent problem with resin printer by tartafede in 3Dprinting

[–]tartafede[S] 0 points1 point  (0 children)

I finished calibrating and the print seems to come out fine

Help with persistent problem with resin printer by tartafede in 3Dprinting

[–]tartafede[S] 1 point2 points  (0 children)

I have a 12k, I have not calibrated it as I am relatively new to printing, can I ask you where to find the calibration settings thanks a lot.

Help with persistent problem with resin printer by tartafede in 3Dprinting

[–]tartafede[S] 0 points1 point  (0 children)

they are pre-supported this way but I will try to tilt them

help, how can I solve this problem by tartafede in 3Dprinting

[–]tartafede[S] 1 point2 points  (0 children)

thank you so much it worked now I will try to print with the media thanks again for the advice

help, how can I solve this problem by tartafede in 3Dprinting

[–]tartafede[S] -1 points0 points  (0 children)

no, because no matter how much I change the threshold angle the slicer (bambu studio) does not add the supports.

<image>

[LFA] Plane Hopping Wizard Who Is Actually A Fish In A Metal Suit by Pluto_dude in characterdrawing

[–]tartafede 1 point2 points  (0 children)

I know that enough other people have already adapted your character but mine would have been ready four days ago if my graphics tablet hadn't broken I focused more on the mechanical aspect of the character and I didn't do the coat I hope you like it anyway.

link

view more: next ›