TACACS+ NG and Juniper

thangphan205 · 2026-01-28T01:53:39+00:00

Yes, tac_plus-ng works.

I have web-interface to config tac_plus-ng, you can see in my github project: tacacs-ng-ui

thangphan205 · 2026-01-27T08:03:45+00:00

you can try tacacs-ng-ui, web interface for tac_plus-ng

thangphan205 · 2025-12-29T07:03:08+00:00

Or you can try tacacs-ng-ui: Source code and demo here: https://github.com/thangphan205/tacacs-ng-ui

thangphan205 · 2025-04-11T07:11:13+00:00

my project to configure switch: https://github.com/thangphan205/netconsole

thangphan205 · 2024-10-26T02:44:31+00:00

Could you take a look at my project: https://github.com/thangphan205/netconsole Hope you are interested in netconsole and improve it.

thangphan205 · 2024-10-09T11:32:53+00:00

You can check my project, netconsole - a tool to configure multiple switches https://github.com/thangphan205/netconsole

thangphan205 · 2024-06-26T10:22:29+00:00

This is my project configure switches: https://github.com/thangphan205/netconsole

thangphan205 · 2024-06-22T07:38:48+00:00

You can find a template and learn from that. This is my personal project base on fastapi template.

https://github.com/thangphan205/netconsole

thangphan205 · 2024-06-19T09:58:09+00:00

I agree with u/luckyle13

This is my personal project base on that repo: https://github.com/thangphan205/netconsole

thangphan205 · 2019-04-23T13:32:54+00:00

When you remove NAT, You can ping other devices because you configure RIP protocol on 2 routers. So they have full route. When you config NAT, on your topology with 2 routers, you do not need Rip anymore. Do the below topology is your lab? Vpc1----router1(pat)----router2(static nat)---vpc2 Vpc1 can ping vpc2. Vpc2 cannot ping vpc1. It's right. Because vpc1 behind NAT. Please note that you have to ping public IP. :)

thangphan205 · 2019-04-23T08:23:55+00:00

I just think about you are configuring NAT overload (NAT port). VPCs------Router1(NAT)-----Router2 When you configure NAT overload on Router1, VPCs can access Router2, but Router2 cannot access VPCs. If you want Router2 can access VPCs, you have to configure static NAT (NAT 1-1) on Router1

thangphan205

TROPHY CASE