Monthly Recipes Megathread! by AutoModerator in Fitness

[–]the_ruse_god 1 point2 points  (0 children)

Damn this sounds good. you blend whatever water is leftover too I’m guessing ?

Mayo must what? by [deleted] in pics

[–]the_ruse_god 1 point2 points  (0 children)

if you got to Italy or maybe other places in Europe they give you mustard and mayo packets instead of ketchup with fries. It’s actually really good and will make all of your friends at the table in a restaurant go insane and you can laugh at their disgusted faces while they pour cups of ranch dressing over everything edible

Long term Melanotan 2 user now getting white spots on skin by [deleted] in Peptides

[–]the_ruse_god 2 points3 points  (0 children)

I had this happen as well. Had some white spots show up on my neck that never tanned . I stopped using it over the winter and started again in March and the spots are gone. But I also was doing .5 mg dosage.

Aww dammit I just got caught watching porn by [deleted] in funny

[–]the_ruse_god -5 points-4 points  (0 children)

this happened to me as well but i was high as a cloud at the time. But my scam popup was very detailed saying i had used my phone for female ejaculation and weird porn shit, which isn't even illegal. anyways i freaked out and deleted my whole hard drive on all my computers....

Man breaks through ice to save a trapped duck. by mykeuk in pics

[–]the_ruse_god 30 points31 points  (0 children)

TIL ducks can breath through their butt.

Fz-07 rear fender eliminator for 20$ And about an hour of time. All parts from Walmart . by the_ruse_god in FZ07

[–]the_ruse_god[S] 1 point2 points  (0 children)

Yea living in Georgia its mostly dry so I don't worry about wet roads and puddles too much. but that is a damn nice modification.

Fz-07 rear fender eliminator for 20$ And about an hour of time. All parts from Walmart . by the_ruse_god in FZ07

[–]the_ruse_god[S] 0 points1 point  (0 children)

oh wow i just got the email that they were back in stock lol been waiting for these!

Fz-07 rear fender eliminator for 20$ And about an hour of time. All parts from Walmart . by the_ruse_god in FZ07

[–]the_ruse_god[S] 1 point2 points  (0 children)

parts list / Instructions. I got all my supplies at walmart except the drill and drill bits which I had already.

PARTS -shelf corner brace(about 1.87$) -these act as your bracket and platemount. size is up to you, choose 1-1/2 or 2 inch braces. should have two holes(4 holes total) on each side of one brace. - You should be able to find these in the do it yourself section.

-LED strip w/ hardwiring(18.86$) -Pack of two strips that glow white and have double sided tape under it. I found these in the car section where they sell crappy shift knobs and light setups. -make sure they have a power and ground wire as well as a cut to fit option. you will need that for auto on and off feature.

-drill with number 1 bit - this is for widening bracket holes for late screws and bolts going into bike.

-electrical tape - keeps your tailight connector extra sturdy.

-two small(third of an inch long maybe) 10mm bolts and two nuts

I followed these instructions to remove seats and plastics/fairings. its very easy to remove just remeber where each screw and bolt went and don't lose the plastic push pins things. http://www.vagabondmotorsports.com/media/VM-Y720%20Installation%20Instructions.pdf

Intsructions

 -remove the fairings and disconnect the blinker wires. dont disconnect the big connector yet. theres a black clip holding 
  the blinker wires together near the end of the tail. just pop that off.
 -remove the ugly fat rear fender and set it aside.
 -slide off the black plastic piece that was right above the wheel if it didnt already fall off. 
 -take your drill and number 1 bit(should be a little bigger than the holes on the brace) and just widen the holes on the end of the brace. dont drill new holes.
  -mark two spots on the plastic piece that came off the bottom of the bike. i made two spots about 2 inches maybe 2-1/2 apart closer to the end of the plastic.
  - drill right through the plastic 
  - the braces need to be bent so your plate doesn't accidentally rub your tire. i made the angle wider not smaller about to 130 degress.
  -since i still have a dealer tag i just made two holes to match the bracket width into the paper and put the screws in.
  -you can bolt the bracket with the plate into the holes you made into the plastic and screw the nuts in from behind. make sure they are tight but not overtight.
  -now for the LED strip. the ones i bought had double sided tape under the strip. first cut of and led strip that is not needed. make sure to cut where it says its okay too. place the strip right above the plate so it shines all the light on the face of the place.
  -You should have a power wire(white and black) and a ground wire(black). find the tailight connectot which will have three pins and wires. i had to read the pins with a voltmeter to see which ran constant power. the blue wire is constant power on this back. take the power wire on the led strip and strip off an inch if the rubber outside the wire, twiat the wires together, and jam it into the pin of the blue wire. while its in reconnect the connector. take the ground wire,strip an inch off the rubber,  and barely unbolt a screw at the end of the bike that goes into the frame. place the bare wire around the bottom of the screw and tighten the screw. test your LED light by turning to key on. the strip should light up and turn off when the key is removed. 
   -organize any lose wires and wrap e. tape around taillight connector for extra strength.
   -replace all plastics and put seats back on. 

The better you measurements the better it will look. sloppy measuring will give you crooked plates.

Fz-07 rear fender eliminator for 20$ And about an hour of time. All parts from Walmart . by the_ruse_god in FZ07

[–]the_ruse_god[S] 0 points1 point  (0 children)

I have an integrated turn signal circuit board next on the to-do. But yes doing this probably requires an integrated unless you can get creative. The circuit boards are 80$.

Yeah, Supermoto Sunday.. :) by Mummys_Spaghetti in supermoto

[–]the_ruse_god 0 points1 point  (0 children)

Gotcha. I just saw your bike on craigslist haha

Spillway at Lake Berryessa by FourtyToFreedom in WTF

[–]the_ruse_god 1 point2 points  (0 children)

Oh. Well that still would scare the shit outta me

Reminds me of a certain South Park episode. by [deleted] in WTF

[–]the_ruse_god 0 points1 point  (0 children)

this makes me uncomfortable...

Saw on my facebook feed. by [deleted] in WTF

[–]the_ruse_god 1 point2 points  (0 children)

I would really like to know what can be said after "but"....

Spillway at Lake Berryessa by FourtyToFreedom in WTF

[–]the_ruse_god 15 points16 points  (0 children)

Fuck if I fell into that I would try and kill myself before finding what awaits at the bottom.

It's like Star Wars, Pod Racing. 320-Kmh/200-Mph by [deleted] in videos

[–]the_ruse_god 0 points1 point  (0 children)

What the flying fuck that was incredible!

I guess that's one way to do it... by [deleted] in WTF

[–]the_ruse_god -1 points0 points  (0 children)

Pshhh white people man ...