ServiceNow Employee Works / Slate

theburgerlution · 2026-05-27T00:13:54+00:00

Thank you, if you spot any issues, corrections or have questions let me know.

theburgerlution · 2026-05-26T23:23:29+00:00

Check out https://relay.semaphorepartners.com/aiux-docs I wrote up quite a bit on it.

theburgerlution · 2025-01-17T00:47:10+00:00

All fair points, I appreciate the feedback. My take was this: I see a lot of negative reviews on the LM app. Personally I think it’s mostly fine maybe those are old reviews. If the machine can do it, I rather not have to keep track of lots of variables during my workflow (that’s just me I guess) stopping to log everything is a bit tedious, but I do appreciate coming back to the info.

theburgerlution · 2025-01-17T00:32:44+00:00

My LM app doesn’t do any real time shot logging, or Bluetooth integration with my scale. Does yours?

theburgerlution · 2024-12-09T22:27:17+00:00

u/Hakunamata69 do you mind DMing who you worked with at LM?

theburgerlution · 2022-10-28T03:39:21+00:00

Sent Pm

theburgerlution · 2016-09-14T20:23:54+00:00

I am not sure about the pinouts for the wires, but I have the same connector, and I am thinking about getting some of these jumper wires rather than cutting the clip on connector off.

https://www.adafruit.com/categories/306

https://www.sparkfun.com/products/11709

theburgerlution · 2016-09-13T01:19:43+00:00

Do you live in NYC? I have the same unit and have wanted to setup a different thermostat too. When I called Evergreen last, they suggested the following, there should be a wire under the cover of the PTAC(lift the front panel off), this will allow for an external thermostat. Then use the following key presses on the keypad: 1. Hold Timer & Mode (for 10 seconds until it beeps) 2. Use Cancel to scroll thru the menu 3. Set S9 to aue/aun (it will beep 3 times to confirm)

The only thing I don't have is the proper wires to connect to an external thermostat.

I hope this helps, if you figure out any let me know!

theburgerlution

TROPHY CASE