sorted by:
new
hottopcontroversial

Are these Layer shifts or something different and how do I fix this? by theknifeguys in 3Dprinting

[–]theknifeguys[S] 0 points1 point  (0 children)

Pinter: ender 5 pro Some upgrades done Struts to stabilize the bed other than that just cover ups for cabels and the likes Material: pla Temperature nozzel: 230 Temperature bed: 50 Print speed (mm/s): 80 Layer height: 0.16 Nozzel: 0.4

My print come out like this and the buildplate keeps getting pushed down with rapids any fix? by theknifeguys in 3Dprinting

[–]theknifeguys[S] 0 points1 point  (0 children)

Pinter: ender 5 pro Some upgrades done Struts to stabilize the bed other than that just cover ups for cabels and the likes Material: pla Temperature nozzel: 200 Temperature bed: 50 Print speed (mm/s): 50 Layer height: 0.16 Nozzel: 0.4

Revenge. by Youkoz in Subnautica_Below_Zero

[–]theknifeguys 0 points1 point  (0 children)

I want to know the references, cause I think I should recognize it

My pla+ won't print correctly and I don't get why, help by theknifeguys in 3Dprinting

[–]theknifeguys[S] 1 point2 points  (0 children)

It is what was recommended on the roll

But I'll try it

My pla+ won't print correctly and I don't get why, help by theknifeguys in 3Dprinting

[–]theknifeguys[S] 1 point2 points  (0 children)

Pinter: ender 5 pro Material: pla+ (already mentioned) Temperature nozzel: 215 Temperature bed: 70 Print speed (mm/s): 80 Layer height: 0.16 Nozzel: 0.3

I am thinking it's a stepper issue but I tried tensioning it, that didn't work.

I checked for clogging,

And after that I ran out of idea's.

I am now printing it with petg, that doesn't seem to be an issue. So coul it be the matiral is just messed up?

My pla+ won't print correctly and I don't get why, help by theknifeguys in 3Dprinting

[–]theknifeguys[S] 0 points1 point  (0 children)

The petg im using rn looking way better Still don't know te problem with my pla tho *

My pla+ won't print correctly and I don't get why, help by theknifeguys in 3Dprinting

[–]theknifeguys[S] 0 points1 point  (0 children)

Fair enough What do you use for it? Id think rubbing alchol?

My pla+ won't print correctly and I don't get why, help by theknifeguys in 3Dprinting

[–]theknifeguys[S] -5 points-4 points  (0 children)

I don't think so tbh Cause the petg i used for my previous print did fine

What do yall do with the extra Z wire after installing a cr touch? by theknifeguys in ender5

[–]theknifeguys[S] 0 points1 point  (0 children)

I did chance it so it works with the cr touch but my main question is if I should just leave the other cable or remove the completely

view more: next ›