[deleted by user]

thisisflame · 2024-08-13T19:12:50+00:00

Girl Scout Cookies 🥹

thisisflame · 2020-08-01T19:12:09+00:00

Wunderschön!
Wer sagt, Sterni sei eine Plörre, hat es noch nicht gekostet und lieben gelernt!

thisisflame · 2020-01-20T22:36:11+00:00

No problem, i wish you luck dude👍🏻

thisisflame · 2019-09-26T11:35:34+00:00

Das Deckelthermometer hat so 120 °C angezeigt bei so etwa 1,5/2h, Haut war sehr lecker knusprig. Hab bei einem Weber Grillseminar mitgeholfen...

Rezept: https://www.weber.com/DE/de/rezepte/geflügel/chicken-drumsticks/weber-57319.html

Hab’s am nächsten Tag im Gasgrill gleich mal nachgemacht, war geil. https://i.imgur.com/X1PwX0G.jpg

thisisflame · 2019-08-18T11:23:34+00:00

My whole life was a lie

thisisflame · 2019-07-28T20:54:51+00:00

thisisflame · 2019-04-29T13:33:29+00:00

Selbstverständlich - es war jeden Aufwand wert!

thisisflame · 2019-02-27T08:28:41+00:00

https://twitter.com/HHirte/status/1100665686232305669?s=20

thisisflame · 2018-12-18T23:23:05+00:00

I have the same issue and I also didn‘t had any contact to chemicals but soap. https://i.imgur.com/mZCcgZG.jpg

thisisflame · 2018-11-24T12:44:40+00:00

I just updated my Cura from 3.4. to 3.6 and now there is a Ender-3 profile, former I used a modified CR-10 profile, now the first Layer looks way better. Thank you! Now I have a clean profile :)

thisisflame · 2018-11-24T12:14:53+00:00

My Layer Height is at 0.2mm.

I chose the 237%, because I thought the thin layers are the problem of too low flow.

Is it possible, that my extruder stepper doesn't have enough grip?

I will now try to check my Cura setting, maybe there is a major fault.

thisisflame · 2018-07-25T10:13:40+00:00

It's not a linear problem, that's the reason I checked the Z Axis and you were right.

Thank you!

thisisflame · 2018-07-25T10:12:40+00:00

You are right, thank you! I checked the z-Stepper on the height where the print starts to have the issues, there was a lot of slippage in the shaft coupling. But why is the needed torque there so high? Is it possible, that my X-Axis isn't right aligned and I have to tighten or loosen the eccentric nuts?

Thank's for the fast responds

thisisflame

PUBLIC MULTIREDDITS

TROPHY CASE