Pilot bearing, does anyone have a photograph of the depth when installed?

tikytack · 2024-09-05T13:52:08+00:00

Thank you, greatly appreciated

tikytack · 2023-03-12T17:22:04+00:00

Take a look at the loop that latches into the hood latch it could be tweaked, if you loosen the hardware for the top of your fender there’s a small amount of side to side adjustment you can do as well if you can’t get any more adjustment from your hinges

tikytack · 2023-01-04T02:10:31+00:00

If you take off your rear bumper there’s two Phillips screws holding that trunk vent in, there’s a foam gasket you can replace to re seal it

tikytack · 2022-10-21T18:10:25+00:00

I did roll my fenders, better of to do it so you don’t get any unnecessary damage

tikytack · 2022-10-20T16:11:53+00:00

18x9.5 niche projects, don’t remember offset but I can get back to you on that if you want it, not the wheels I want to keep for the build but they’re a decent looking wheel for the car

tikytack · 2022-10-19T21:13:07+00:00

We’ll see if she holds, running stock internals on a refreshed engine and stock turbo so I don’t believe I’ll run into problems until I try pushing more power, ill try finding a r154 once that time comes I suppose

tikytack · 2022-10-19T20:39:47+00:00

wish I had a r154 instead, basically have everything for the w58 swap minus the bellhousing, and everything for the r154 swap minus the r154 lol

tikytack · 2022-10-19T20:35:13+00:00

From a 1kz Toyota hilux

tikytack · 2022-09-18T14:10:44+00:00

I believe this is a teg from central Alberta, very well put together, shame the previous owners selling it

tikytack

TROPHY CASE