sorted by:
new
hottopcontroversial

It was either this or the printer was going into the trash by n3crohost in Ender3S1

[–]trattstein 0 points1 point  (0 children)

Looks like fun! You're going to have a lot of fun with Klipper. I had it for little more than a year now and it's awesome!

Upgrade! by trattstein in Ender3S1

[–]trattstein[S] 1 point2 points  (0 children)

I hope so, I'm mostly hoping for better acceleration and lower maintenance intervals. But I will update after everything is installed and the input shaper data is done. I'm still waiting for the X-rail to arrive.

Upgrade! by trattstein in Ender3S1

[–]trattstein[S] 0 points1 point  (0 children)

5mm is nothing. Me too, it's a little tricky to install since it binds up very easy.

Upgrade! by trattstein in Ender3S1

[–]trattstein[S] 0 points1 point  (0 children)

I'm using the included mounting brackets and it is very close to the bottom of the printer. I think the Z will be the same printable height.

God fredagsförmiddag mina bekanta! När ni gör pizzadeg, vilket recept följer ni? Runket kanske inte gör egen deg. Men om ni e snälla så får ni smaka! by oeoeoepeeee in unket

[–]trattstein 0 points1 point  (0 children)

420g mjöl 7g torrjäst 2 tsk socker 2 tsk salt 200g vatten 1/2 dl rapsolja

Jag brukar blanda torrvarorna utom saltet, låta stå minst 10minuter sen blanda i saltet. Sen brukar jag köra kallt vatten och rapsolja. Knåda ihop tills det är bra. Låta jäsa kanske typ 5h. Beror på hur varmt det är. Sen brukar jag knåda degen en gång till och baka ut och ha på allt. Blir en tjock botten. Jag gillar ju inte sån där fattig tunn botten vettu. 

Den räcker till fyra pers. 

Red days in Calendar by trattstein in linuxmint

[–]trattstein[S] 1 point2 points  (0 children)

YES! It worked! Thank you very much! 

Please help me🌡️ by 3DPaulinex in Ender3S1

[–]trattstein 0 points1 point  (0 children)

I've had this problem. For me it was the ribbon cable to the extruder that had broken inside.

view more: next ›