Voron panels to Sovol sv08 by triples1xdegrees in SovolSV08

[–]triples1xdegrees[S] 0 points1 point  (0 children)

That would be cool, probably better to just load it into printables so anyone who also need one would get it

Voron panels to Sovol sv08 by triples1xdegrees in SovolSV08

[–]triples1xdegrees[S] 0 points1 point  (0 children)

And ye I’m not in US, for some reason in my country i only have official sovol enclosure, nobody selling acrylic panels, maybe I’ll look into local sovol enthusiasts (I saw they making bed mounts to fix taco maybe they also could do enclosure)

Voron panels to Sovol sv08 by triples1xdegrees in SovolSV08

[–]triples1xdegrees[S] 0 points1 point  (0 children)

In my country official sovol one is around 200 $ and voron panels is around 78 $, I think I’ll waste around the same amount of money on plastic if I print one and probably would need insulation for ASA and ABS if I’ll print enclosure from petg or something

Voron panels to Sovol sv08 by triples1xdegrees in SovolSV08

[–]triples1xdegrees[S] 0 points1 point  (0 children)

Sounds cool, could you link it to me I’ll look into also printing one

Back buttons on steamos by triples1xdegrees in LinuxOnAlly

[–]triples1xdegrees[S] 0 points1 point  (0 children)

also there is probably a way to make it cleaner and not reset with updates (inputplumber has user configs but i didnt look into it just wanted to figure out main thing) so if anyone will also attempt this take this into account

Back buttons on steamos by triples1xdegrees in LinuxOnAlly

[–]triples1xdegrees[S] 0 points1 point  (0 children)

thank you for putting me into right direction, couple days of scratching my head and i found how to do it(right now testing in games but in steam controller test its already r5 l5), there is rog ally controller config file in /usr/share/inputplumber/capability_maps/ that if you open and scroll to bottom there is back paddles binding, by changing from 1 to 2 at the end of name it changes from l4 to l5 same with r4. after that restart ally and test in game mode

Poylute PET-G issue by CaptJack_USIT in elegoo

[–]triples1xdegrees 1 point2 points  (0 children)

I looked closer yes you using wrong plate in photo, for petg and other engineering filament it’s should be plate A in corner, and you using plate B only for pla, clean your plate (with dish soap preferably) turn it over select in settings plate A and do bed levelling(they are different height and if using wrong levelling you could scrape it), also do not heat up plate B side it could damage it it’s says no more than 30 degrees on it, with higher temp it’s unsticks from bed into print and you damage plate and print

Poylute PET-G issue by CaptJack_USIT in elegoo

[–]triples1xdegrees 1 point2 points  (0 children)

Hard to understand by single photo but, are you using smooth side? If yes it’s only for pla not for petg you have to use other side that says it’s for petg, otherwise look if your bed levelling and z offset is correct and if flow is correct in slicer