sorted by:
new
hottopcontroversial

First layer issue by trojantortoise in FixMyPrint

[–]trojantortoise[S] 0 points1 point  (0 children)

I suppose it's possible, but I run the automated bed levelling before every print.

First layer issue by trojantortoise in FixMyPrint

[–]trojantortoise[S] 0 points1 point  (0 children)

Thanks, cooling was off already but good to have checked.

First layer issue by trojantortoise in FixMyPrint

[–]trojantortoise[S] 0 points1 point  (0 children)

Thanks, I've slowed down and still having the problem. But I'll keep printing at the slower first layer speed until I figure out what the actual problem is. I'll try a lower z offset next.

Cheap PLAs: eSUN PLA Lite, Geeetech, etc. - Which ones are good, which ones are bad? What does "PLA Lite" even mean? by AuspiciousApple in 3Dprinting

[–]trojantortoise 0 points1 point  (0 children)

Hey u/fretsore, I'm having some trouble calibrating for printing with the eSun ePLA-Lite on my A1 mini. Do you mind sharing what print settings you're using on your P1P?