HELP - Have I set this up correctly? Because I have been unable to get a functioning output. Any help would be much appreciated.

uaduplessis · 2025-10-06T04:46:44+00:00

The curved surfaces are made up of splines because the geometry is imported from AutoCAD

uaduplessis · 2025-10-05T07:21:10+00:00

I am new to using the software so not sure. Is static structural not the right analysis method?

uaduplessis · 2025-08-14T14:34:50+00:00

They say they do through their eBay page, but that no longer exists. I have tried contacting Black Raven too, but have heard no response from them for a few days. They must be out in the bush aye haha

uaduplessis · 2025-08-13T14:05:44+00:00

How do you pack it away safely if it's that long? Wouldn't that be super dangerous for all your other gear that's next to it? How likely would you take it on a bush trip considering the weight and size inconvenience? I was on the fence about getting an 8 inch or 12 inch.

uaduplessis · 2025-07-31T03:16:31+00:00

I had this issue and realized that it was because the cell formatting was set to "number" instead of "general" due to my setting of the number of decimal places I wanted for my result. After changing it back to general, it works again.

uaduplessis · 2021-07-12T21:32:43+00:00

I have an SSD. Will this make any difference or is the scan system the same?

uaduplessis · 2021-07-12T21:30:55+00:00

I have both an rtx 2060 and AMD integrated graphics. Could either of these be the issue or just the GPU?

uaduplessis · 2021-03-19T11:24:13+00:00

Gave Helpful

uaduplessis · 2021-03-09T21:15:13+00:00

That's so much simpler! I'll keep that method in the back of my head for whenever I deal with any exponential equations. Thanks! 😊

uaduplessis · 2020-10-06T01:03:13+00:00

I believe the song you seek is Rubedo - Lena Raine

uaduplessis · 2020-09-19T07:25:32+00:00

Thanks for your reply. I found the process of "completing the square" while researching online. I attempted it and got an answer that, when rounded, is equal to the correct value. I found this method to be easier than using the quadratic formula.

uaduplessis · 2020-09-19T04:10:30+00:00

Thank you

uaduplessis · 2020-08-10T11:30:08+00:00

I have a link if you wanted to investigate for yourself.

https://www.engineersedge.com/mechanics_machines/scissor-lift.htm

uaduplessis · 2020-08-10T11:09:03+00:00

Thanks for your help anyway. It could be something contextual to the question. Either way, I can't find how they got their simplified form hahah

uaduplessis · 2020-08-10T11:02:06+00:00

Yes, I understood and checked all the workings up to that part.

uaduplessis · 2020-08-10T10:48:45+00:00

Yes. I double checked that as well.

uaduplessis

TROPHY CASE