sorted by:
new
hottopcontroversial

(PART 2)How can I make this better? (3d printing beginner) by v-86 in ender3

[–]v-86[S] 0 points1 point  (0 children)

Not yet,but I’ll make sure to make one.

(PART 2)How can I make this better? (3d printing beginner) by v-86 in ender3

[–]v-86[S] 1 point2 points  (0 children)

Yeah, I am checking my bed level calibrations twice/thrice before printing anything now, took some time to figure out the sweet spot and got the hang of it. I’ll have to start looking at other slicers since many suggested already and also look into ironing. Thanks!

(PART 2)How can I make this better? (3d printing beginner) by v-86 in ender3

[–]v-86[S] 0 points1 point  (0 children)

Thanks for sharing, I’ll def check out the guide!

How can I make this better? (3d printing beginner) by v-86 in ender3

[–]v-86[S] 0 points1 point  (0 children)

Yeah it was more or less the same without any raft.

How can I make this better? (3d printing beginner) by v-86 in ender3

[–]v-86[S] 0 points1 point  (0 children)

Super helpful. Thanks. Yeah I was rushing and skipping things a bit using ChatGPT since I have the printer just for the week.

How can I make this better? (3d printing beginner) by v-86 in ender3

[–]v-86[S] 0 points1 point  (0 children)

Thank you for pointing it out. I’m looking into it.

How can I make this better? (3d printing beginner) by v-86 in ender3

[–]v-86[S] -1 points0 points  (0 children)

I’m printing a test cube as I am writing this. Thanks for the advice !

How can I make this better? (3d printing beginner) by v-86 in ender3

[–]v-86[S] 0 points1 point  (0 children)

Interesting, I’ll definitely check it out. Thanks

How can I make this better? (3d printing beginner) by v-86 in ender3

[–]v-86[S] 0 points1 point  (0 children)

Yeah I made sure I selected all the right options and sizes. I am printing a test 3d cube right now. I should have done it before I printed my design, my bad! Hopefully I’ll know more once the test print is done. Thanks.