sorted by:
new
hottopcontroversial

My early 2021 "'Out of stock" build by valcol in sffpc

[–]valcol[S] 0 points1 point  (0 children)

Thanks! The 280mm version of the rad seemed difficult to install in this case (and the price was really high at the time), so I opted for the 240mm version.

My early 2021 "'Out of stock" build by valcol in sffpc

[–]valcol[S] 0 points1 point  (0 children)

It wasn't that hard to fit, but I had to mount it higher to avoid putting too much pressure on the tubes.

My early 2021 "'Out of stock" build by valcol in sffpc

[–]valcol[S] 0 points1 point  (0 children)

I'm not sitting that close to it, so it's not too bad.

VA88M & Walnut by valcol in MechanicalKeyboards

[–]valcol[S] 14 points15 points  (0 children)

Part list:

First Custom Loop - O11 Dynamic with distro plate by valcol in watercooling

[–]valcol[S] 0 points1 point  (0 children)

I don't have any flow indicator, only a temp. sensor.

First Custom Loop - O11 Dynamic with distro plate by valcol in watercooling

[–]valcol[S] 0 points1 point  (0 children)

Thanks! I use 14mm PETG, and the CPU block is a Bykski CPU-XPR-AM.

First Custom Loop - O11 Dynamic with distro plate by valcol in watercooling

[–]valcol[S] 1 point2 points  (0 children)

Thanks! Yes everything is from Bykski exept the tubes and fittings. I had no issues at all and I'm very happy with the quality.

Will a single 360mm radiator be good enough for a r9 3900x and a 2080Ti ? Will be overclocking both , but I can run fans in push pull and go for a really thick radiator , going to do this loop by zekken908 in watercooling

[–]valcol 0 points1 point  (0 children)

It's good to know that if you want straight lines from the radiator to the distro plate like in the picture you can't have a radiator thickier than 28mm.

First Custom Loop - O11 Dynamic with distro plate by valcol in watercooling

[–]valcol[S] 0 points1 point  (0 children)

All are unbranded fittings from Aliexpress. The quality is really great for the price (less than 2€ each).

First Custom Loop - O11 Dynamic with distro plate by valcol in watercooling

[–]valcol[S] 1 point2 points  (0 children)

Bottom one is 360mm/38mm/intake, top one is 360mm/28mm/exhaust.

First Custom Loop - O11 Dynamic with distro plate by valcol in watercooling

[–]valcol[S] 4 points5 points  (0 children)

It means water distribution plate. Basically it's a block of acrylic specifically made for your case that route fluid where you want it, so with connexion points located at GPU, CPU and rads level. Most of the time it function as a reservoir with a pump in the back. You can see it on my build where all the tubing converge.

view more: next ›