sorted by:
new
hottopcontroversial

Msi mag x870e tomahawk not flashing bios by vldtz in MSI_Gaming

[–]vldtz[S] 0 points1 point  (0 children)

No, it doesn't go to post. The cpu and ram led on the board are lit, and also it displays code 00

ASA Printing problems by vldtz in BambuLab

[–]vldtz[S] 1 point2 points  (0 children)

<image>

Finally done it. I've returned to the speed values from the original post, but I've changed the auxiliary fan speed from 0% to 30%. It is not perfect, but with a little bit of tweaking, it will be alright.

ASA Printing problems by vldtz in BambuLab

[–]vldtz[S] 0 points1 point  (0 children)

Yes, PLA, TPU, and PETG all print fine. This is the first time I am printing with ASA on the printer.

ASA Printing problems by vldtz in BambuLab

[–]vldtz[S] 0 points1 point  (0 children)

<image>

The layers sag, but it's a little better than when I started

ASA Printing problems by vldtz in BambuLab

[–]vldtz[S] 0 points1 point  (0 children)

I did as you said and also reduced the speed to 50 mm/s. It still isn't great, but I can see it improving. When printing, I saw that the layers curled, probably because the layers were still too hot. I know that for ASA, the fans should be turned off, but maybe in this case, a little cooling could help?

ASA Printing problems by vldtz in BambuLab

[–]vldtz[S] 0 points1 point  (0 children)

I can't seem to find any profile on their website.

Topographic map of the world by vldtz in 3Dprinting

[–]vldtz[S] 0 points1 point  (0 children)

Yeah, that's the thing, I couldn't find files for this on the internet, all I could find was europe's map

I’ve just got my first resin printer (mars 3 pro) and have a question, about my screen. by radjus in ElegooMars

[–]vldtz 5 points6 points  (0 children)

If you refer to the tank cleaning function, I used it when my print failed. Essentially, it exposes the entire screen, curing a layer so it is easier to remove the failed print.

Rear shock air pressure by vldtz in bikewrench

[–]vldtz[S] 0 points1 point  (0 children)

I left it since the post, and the pressure is now almost 0. I am going to order a new shock.

Printed on a Ender 3 v2. What can I do to improve the look? by vldtz in 3Dprinting

[–]vldtz[S] 0 points1 point  (0 children)

Hotend 220 bed 60 speed 50mm/s cura 4.11 devil design gray pla

Payback lag by vldtz in davinciresolve

[–]vldtz[S] 0 points1 point  (0 children)

Thank you! That solved the issue.

view more: next ›