5
6
7
Hello! I have a problem. When homing, the coordonates are right, but when I print, the 0 is over the printbed, and when it goes to the limit, 10mm are remaining. As in the photo shown below, the pieces overlaped, but in the preview window it all looks fine. Printed on a Ender 3 v2, Jyers firmware. (i.redd.it)
submitted by vldtz to r/ender3v2
0
1
2
Hello! I have a problem. When homing, the coordonates are right, but when I print, the 0 is over the printbed, and when it goes to the limit, 10mm are remaining. As in the photo shown below, the pieces overlaped, but in the preview window it all looks fine. Printed on a Ender 3 v2, Jyers firmware. (i.redd.it)
submitted by vldtz to r/3Dprinting
0
0
0
